DRAFT - Danfoss Heating for consumers
DRAFT - Danfoss Heating for consumers
DRAFT - Danfoss Heating for consumers
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Daily use<br />
Temperatures<br />
Push any button to switch on the backlight.<br />
<br />
<br />
Setting the desired room temperature<br />
Change the desired temperature.<br />
The setting of the desired room temperature is important even if a room temperature sensor<br />
/ room panel / remote control is not connected.<br />
Is the room temperature too low?<br />
Make sure that the radiator thermostat(s) does not limit the room temperature.<br />
If you still cannot obtain the desired room temperature by adjusting the radiator<br />
thermostats, the flow temperature is too low. Increase the desired room temperature.<br />
Temperature overview<br />
2 sec.<br />
Push the button to see the sensor (S1-S4) temperatures.<br />
Change between the temperature displays:<br />
S1:<br />
Actual outdoor temperature<br />
Accumulated outdoor temperature<br />
<br />
<br />
S2:<br />
Actual room temperature <br />
Desired room temperature <br />
S3:<br />
Actual flow temperature <br />
Desired flow temperature <br />
S4:<br />
Actual return temperature <br />
Desired return temperature limitation <br />
8 VI.KT.G2.02 © <strong>Danfoss</strong> 05/2007 DH-SMT/DK<br />
Checklist, electrical connections<br />
Is the ECL Com<strong>for</strong>t controller ready <strong>for</strong> use?<br />
<br />
Make sure that the correct power supply is connected to terminals 21 (Live)<br />
and 20 (Neutral).<br />
Check that the required controlled units (actuator, pump etc.) are connected<br />
to the correct terminals.<br />
Check that all sensors are connected to the correct terminals.<br />
Switch on the power.<br />
Choose manual operation as controller mode.<br />
Check that valves open and close, and that required controlled units (pump<br />
etc.) start and stop when operated manually.<br />
Check that the temperatures shown in the display match the actual sensors.<br />
DH-SMT/DK VI.KT.G2.02 © <strong>Danfoss</strong> 05/2007 45
Change language