34169522 - heidenhain - DR. JOHANNES HEIDENHAIN GmbH

More documents

Recommendations

Info

Scaling Factor 28 Working with a Scaling Factor Scaling factors enable you to increase or decrease the display values based on the actual traverse distance. The display values are changed symmetrically about the datum. Enter scaling factors separately for each axis in parameter P12. Parameter P11 activates and deactivates the scaling factors in all axes (see “ Operating Parameters” ). Example for enlarging a workpiece: P12.1 3.5 P12.2 3.0 P11 ON This results in a larger workpiece as shown in the illustration at right: 1 is the original size, 2 is with axis-specific scaling factors. If a scaling factor is active, SCL lights in the status display. 0 Y 0 ∗ 3.0 1 2 ∗ 3.5 X
Error Messages Message Cause and effect SIGNAL X Encoder signal is too small, e.g. when an encoder is contaminated. PROB. ERROR Before touching off on the workpiece, the tool must move by a distance of at least 0.2 mm. ERR. REF. X The spacing of the reference marks as defined in P43 is not the same as the actual spacing. FRQ. ERR. X The input frequency for this encoder input is too high. This can occur when the scale is moved too fast. ERR. MEMORY Check sum error: Check the datum, operating parameters and compensation values for multipoint axis error compensation. If the error recurs, contact your service agency! To erase error messages: After you have removed the cause of error: ➤ Press the CL key. Error Messages 29
Page 1 and 2: User’s Manual Position Display Un
Page 3 and 4: This manual is for the ND display u
Page 5 and 6: Datum setting The workpiece drawing
Page 7 and 8: Nominal position, actual position a
Page 9 and 10: Switch-On, Traversing the Reference
Page 11 and 12: Probing a workpiece edge to find a
Page 13 and 14: ENT 0 ENT Z PROBE Z (appears only b
Page 15 and 16: PROBE EDGE ANTASTEN or MITTE PROBE
Page 17 and 18: PROBE CIRC. ENT 1ST POS X (appears
Page 19 and 20: Tool Compensation You can enter the
Page 21 and 22: X 3 0 R + - Y 5 0 R + - SPEC FCT or
Page 23 and 24: SPEC FCT SPEC FCT BOLT HOLE FULL CI
Page 25 and 26: Linear Hole Patterns The linear hol
Page 27: NUMBER ROW 3 ROW SPACE 2 START ENT
Page 31 and 32: Items Supplied 32 Items Supplied ND
Page 33 and 34: Mounting/Power Connection 34 Mounti
Page 35 and 36: Operating Parameters 36 Operating P
Page 37 and 38: Operating Parameters 38 P41.1 to P4
Page 39 and 40: Linear Encoders 40 Parameter settin
Page 41 and 42: Multipoint Axis Error Compensation
Page 43 and 44: Specifications 44 Specifications Ho
Page 45: DR. JOHANNES HEIDENHAIN GmbH Dr.-Jo

34169522 - heidenhain - DR. JOHANNES HEIDENHAIN GmbH

Create successful ePaper yourself

Delete template?

Save as template?