Loudspeakers - Dynacord

More documents

Recommendations

Info

CXM 15 / CXM 15W CXM 15 / CXM 15W COAXIAL MONITOR SPEAKER CABINET 90 • Coaxial Monitor 15“ / 1.4“ 2-Way • 102 dB SPL / 1 W / 1m • Max. 135 dB SPL / 1 m • Light Weight 19 kg • Switchable to Biamp Mode • FIR and IIR Presets available OPTIMIZED FACTORY PRESETS INCLUDING FIR-TUNE LINEARIZATION ARE AVAILABLE FOR DSP 600, P 64 AND PowerH AMPLIFIERS WITH RCM-26 UNDER IRIS-NET.
The DYNACORD CXM 15 is a lightweight wedge for professional monitoring applications. The DYNACORD DCX15450 two-way 15“ / 1.4“ transducer uses a coaxially mounted HF unit and can be used in passive or bi-amped operating mode. The acoustic crossover frequency between the 15“ low-frequency transducer and the 1.4“ mid-high compression driver is at 1.2 kHz. The slope of the built-in passive crossover network is 12 dB / octave. Extremely precise vocal definition is assured by the comparatively low crossover frequency and the coaxial transducer design. Power amplifiers are connected to the CXM 15 via Speakon NL4MPR connectors. The pin assignment in passive mode is 1+ / 1-. Switching from passive mode to bi-amped mode is performed by operation of a slider switch. In bi-amping mode, pins 1+ / 1- are connected to the 15“ low frequency section of the CXM 15 and pins 2+ / 2- to the 1.4“ mid-high-frequency section. The CXM 15 is equipped with three Speakon sockets switched in parallel. This simplifi es the daisy-chaining of multiple wedges and pole-mounted CXM 15 cabinets. The 1.4“ MF/HF compression driver is safeguarded against thermal overload by the fully-electronic Voice Coil Tracking Protection system, which exhibits „soft“ switching characteristics, sparing audiences the annoying CXM 15 / CXM 15W clicks and pops that are the bugbear of conventional solutions. Both FIR and IIR presets are available for a wide variety of operating modes. The CXM 15 is constructed from birch plywood and therefore extremely resistant to abuse on the road. All cabinet connections are slotted and glued. The surface is protected by a hard-wearing textured finish. A powder-coated steel grille backed by acoustic foam protects the loudspeaker components from accidental damage. A recessed adapter is provided to facilitate pole-mounting. Handles have been integrated into both sides of the CXM 15. A version of the CXM 15 in white is also available: the CXM 15W. 91
Page 1 and 2:
Loudspeaker Systems MORE THAN 60 YE
Page 3 and 4:
TECHNICAL SPECIFICATIONS D-Lite 122
Page 5 and 6:
In 1945 Werner Pinternagel, who was
Page 7 and 8:
A high degree of innovation, uncomp
Page 9 and 10:
BOSCH PRODUCTION SYSTEM Bosch Produ
Page 11 and 12:
measurement halls. A reverberation
Page 13 and 14:
D-Lite · D 8 · D 8A · D 11A · D
Page 15 and 16:
D 12T D 12RW The full-range speaker
Page 17 and 18:
POWERSUB 312 POWERSUB 315 D-LITE Su
Page 19 and 20:
It is remarkable in its class for t
Page 21 and 22:
D 8A POWERED FULLRANGE CABINET The
Page 23 and 24:
D 11A A POWERED D FULLRANGE CABINET
Page 25 and 26:
The 12“ DL 12 BFH high-power tran
Page 27 and 28:
Uncolored, extremely low-distortion
Page 29 and 30:
15-3 DESIGNS ARE AMONG MONG THE CLA
Page 31 and 32:
PowerSub 112 POWERED SUBWOOFER The
Page 33 and 34:
Page 35 and 36:
Page 37 and 38:
D-Lite te 2000 SYSTEM M System comp
Page 39 and 40: D-Lite activeone ACTIVE THREE-WAY S
Page 41 and 42: ACCESSORIES Top D 8 D 8W Color Blac
Page 43 and 44: Corus Evolution · C 12.2 · C 15.2
Page 45 and 46: SUB 1.15 SUB 1.18 SUB 2.18 The Coru
Page 47 and 48: C 15.2 FULLRANGE CABINET ABINET In
Page 49 and 50: C 25.2 FULLRANGE CABINET C 25.2 If
Page 51 and 52: Sub 2.18 SUBWOOFER The Sub 2.18 is
Page 53 and 54: VariLine · VL 62 / VL 62W · VL 26
Page 55 and 56: VL 212 12 SUB 18 SUB 28 Professiona
Page 57 and 58: LOUDSPEAKERS VariLine loudspeakers
Page 59 and 60: VL 62 and VL 262 TWO-WAY FULLRANGE
Page 61 and 62: The 12“ and 15“ VariLine models
Page 63 and 64: These are mounted on the back to pr
Page 65 and 66: SUB 28 and VL 212 SYSTEM A combinat
Page 67 and 68: ACCESSORIES Top VL 62 VL 62W VL 262
Page 69 and 70: TS 400 · TS 400 TS 400 69
Page 71 and 72: The TS 400 is equipped with 4 x 6,5
Page 73 and 74: PSD/E POWERED SUBWOOFERS PSD/E Powe
Page 75 and 76: PSE 218 PSD/E POWERED SUBWOOFERS Th
Page 77 and 78: Both models are vented direct-radia
Page 79 and 80: Both models use a highly efficient
Page 81 and 82: PSE 215 and PSE 218 NON POWERED SUB
Page 83 and 84: VERTICAL ARRAY SYSTEMS Vertical Arr
Page 85 and 86: Many high performance systems can b
Page 87 and 88: VA 215 SYSTEM VA 218 SYSTEM System
Page 89: CXM 15 · CXM 15 / CXM 15W · AM 12
Page 93 and 94: XA 2 SYSTEMS Xa 2 Systems · FX 12
Page 95 and 96: XA 2 SYSTEMS OPTIMIZED FACTORY PRES
Page 97 and 98: SUB UNIT The Planar Waveguide Bassh
Page 99 and 100: FX 20 PLANAR WAVEGUIDE SUB To gener
Page 101 and 102: COBRA SYSTEMS Cobra Systems · Cobr
Page 103 and 104: COBRA-4 TOP which far more is expec
Page 105 and 106: SIGNAL FLOW IN CONTROLLER IRIS-NET
Page 107 and 108: SYSTEM COMPONENTS COBRA-SUB Flyable
Page 109 and 110: SYSTEM COMPONENTS COBRA-PWH A plana
Page 111 and 112: Rigging Accessories 01 TC-04 - Trus
Page 113 and 114: ICP-88 ICP-48 ICP-44 CP-48 AC 232 S
Page 115 and 116: COBRA-2 SYSTEM OPTIMIZED FACTORY PR
Page 117 and 118: COBRA-4 SYSTEM 117
Page 119 and 120: ALPHA SYSTEMS Alpha System · X-1
Page 121 and 122: ALPHA X-1 AND ALPHA B-3 121
Page 123 and 124: D-Lite Type / Name Sub 112 Cabinet
Page 125 and 126: VariLine TECHNICAL SPECIFICATIONS V
Page 127 and 128: CXM 15 / CXM 15W TECHNICAL SPECIFIC
Page 129 and 130: APPLICATION GUIDE Application Guide
Page 131 and 132: D-Lite activethree SMALL CLUBS, MOB
Page 133 and 134: D-Lite MUSICIANS, SMALL CLUBS, MOBI
Page 135 and 136: Corus Evolution LIVE, MOBILE DJ‘S
Page 137 and 138: VariLine CLUB, BARS, BISTRO 4 x VL
Page 139 and 140: VariLine MUSICIANS, MOBILE DJ‘S,
Page 141 and 142:
Vertical Array System APPLICATION G
Page 143 and 144:
Xa 2 APPLICATION GUIDE Xa 2 HI-POWE
Page 145 and 146:
COBRA-2 COMPACT LINE-ARRAY SYSTEM F
Page 147 and 148:
COBRA-4 LINE-ARRAY SYSTEM FOR LARGE
show all

Loudspeakers - Dynacord

Create successful ePaper yourself

Delete template?

Save as template?