Indoor Unit Outdoor Unit CS-HE9NKE CS-HE12NKE CS ... - LMG
Indoor Unit Outdoor Unit CS-HE9NKE CS-HE12NKE CS ... - LMG
Indoor Unit Outdoor Unit CS-HE9NKE CS-HE12NKE CS ... - LMG
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
• nanoe-G check mode<br />
o To enable nanoe-G check mode, during nanoe-G operation ON:<br />
SET<br />
Remote control normal mode<br />
Press continuously for 15s<br />
SET<br />
SET<br />
SET<br />
Transmit ECO demo code<br />
and after 2 seconds return to normal<br />
mode.<br />
Transmit check code<br />
and after 2 seconds return to normal<br />
mode.<br />
Transmit sunlight sensor check code<br />
and after 2 seconds return to normal<br />
mode.<br />
o If there is abnormal discharge, nanoe-G indicator blinks immediately.<br />
• Error detection control<br />
When nanoe-G indicator blinks, it indicates error listed below:<br />
o Nanoe-G connector at main PCB open<br />
Judgment method<br />
• During nanoe-G operation, nanoe-G connector at main PCB is opened.<br />
Troubleshooting method<br />
• Connect the connector or stop operation to cancel the blinking.<br />
o Abnormal discharge error<br />
Judgment method<br />
• During nanoe-G operation, the nanoe-G system has abnormal discharge due to short-circuit caused<br />
by water or dust adhesion and so forth, with Lo-feedback voltage (at microcontroller).<br />
• When abnormal discharge occurred, every 30 minutes the unit supplies power to the nanoe-G<br />
system.<br />
• When abnormal discharge occurs for 24 times continuously, nanoe-G indicator blinks.<br />
Troubleshooting method<br />
• Press nanoe-G button or OFF/ON button to stop the operation and check the nanoe-G connector at<br />
PCB.<br />
• After that, press nanoe-G button again to confirm the nanoe-G indicator do not blinks.<br />
• The 24 timer counter will be clear after 10 minutes of normal operation or when operation stops.<br />
Error reset method<br />
• Press “OFF/ON” button to OFF the operation.<br />
• Press AUTO OFF/ON button at indoor unit to OFF the operation.<br />
• OFF Timer activates.<br />
• Power supply reset.<br />
41