PGO G-Max (M2) servicemanual - Scootergrisen
PGO G-Max (M2) servicemanual - Scootergrisen
PGO G-Max (M2) servicemanual - Scootergrisen
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
A.Dismantling engine<br />
1.Take off the luggage compartment.<br />
2.Take off the left and right body<br />
covers.<br />
3.Take off the air cleaner fixing screws.<br />
4.Loosen 2 nuts of intake manifold, withdraw<br />
intake system assembly.<br />
5.Remove vacuum pipe, fuel pipe ,auto<br />
choke, cap of spark plug, rear<br />
brake cable carburetor pipe, starter motor cable.<br />
6.Remove the rear section of muffler, dismantle<br />
the 2 bolts of rear brake caliper, then remove the<br />
rear brake system assembly away from rear fork.<br />
7.Loosen bolts of upper & lower engine hanger.<br />
8.Remove the engine.<br />
B.Installing Engine<br />
1.To install engine, please reverse the<br />
Above procedures.<br />
2.Locking torque:<br />
M8: 2.0-3.0kgf.m<br />
M10: 3.0-4.0kgf.m<br />
M12: 5.0-6.0kgf.m<br />
3.After installing, pleas do the following<br />
Checking and adjustment:<br />
a. Wiring for each circuit.<br />
b. Throttle cable<br />
c. Rear brake check.<br />
d. fuel and oil route
Change language