Wireless High Frequency Transceiver Module (RF GFSK)

More documents

Recommendations

Info

RF_RECEIVE: BC P6, 7 ; CS BC P6, 3 ; CE CALL DELAY5US CALL DELAY5US MOV A, @0X20 MOV 0X4, A MOV A, @0X1A ; 208 bit MOV 0X10, A CLR BYTE RF_BYTE_LP: RF_BIT_LP: MOV A, @0X8 MOV 0X11, A RLC BYTE BS P6, 5 ; CLK1 JBS P6, 4 ; DATA BC BYTE, 0 JBC P6, 4 ; DATA BS BYTE, 0 BC P6, 5 ; CLK1 DJZ 0X11 JMP RF_BIT_LP INC 0X4 DJZ 0X10 JMP RF_BYTE_LP CALL DELAY5US CALL DELAY5US BS P6, 3 ;CE RET http://www.wenshing.com.tw ; http://www.rf.net.tw TRW-24G Data Sheet P.50
;======================================== ; ========= DELAY1MS SUBROUTINE ========== ;======================================== DELAY1MS: MOV A, @0X0FF JMP DLY_SKIP DELAY200US: DELAY5US: DLY_SKIP: DLY_LOOP: MOV A, @0X32 JMP DLY_SKIP MOV A, @0X1 MOV DLY_REG,A NOP NOP NOP DJZ DLY_REG JMP DLY_LOOP RET ;======================================== ;========= INTERRUPT SUBROUTINE ========= ;======================================== INT_0: INT_1: http://www.wenshing.com.tw ; http://www.rf.net.tw TRW-24G Data Sheet P.51
Page 1 and 2: TRW-24G WENSHING®© V1.04 Wireless
Page 3 and 4: Specification : Conditions: VDD=+3V
Page 5 and 6: http://www.wenshing.com.tw ; http:/
Page 7 and 8: ShockBurst TM principle: When the T
Page 9 and 10: RF front end is powered up. RF pac
Page 11 and 12: Figure 4 Simultaneous 2 channel rec
Page 13 and 14: Configuration word overview: Table
Page 15 and 16: The MSB bit should be loaded first
Page 17 and 18: NOTE: An 8 bit CRC will increase th
Page 19 and 20: The data packet for both ShockBurst
Page 21 and 22: Example: ShockBurth in the receive
Page 27 and 28: 0 0 0 1 0 1 0 0 Example: In direct
Page 29 and 30: Example: In direct receive mode, it
Page 31 and 32: Example: In direct receive mode, it
Page 33 and 34: Figure 9 VDD off to active mode Not
Page 35 and 36: ShockBurst TM RX: Figure 12 Timing
Page 37 and 38: DLY_REG EQU 0X1C KEY_REG EQU 0X1B T
Page 39 and 40: IOW 0XD MOV A, @0X08 ; P5, 0- LED P
Page 41 and 42: CALL DELAY1MS MOV A, P6 AND A, @0X0
Page 43 and 44: AND A, @0X07 MOV BYTE, A JBC P5, 3
Page 45 and 46: R_RET: MOV A, @0X10 MOV 0X13, A CAL
Page 47 and 48: ;===== RF CONFIG SUBROUTINE ======
Page 49: DJZ 0X10 JMP RF_S_ADD_BYTE MOV A, @
Page 53 and 54: } /* ------------------------------
Page 55 and 56: = 1 , Modules work is in the ShockB
Page 57: } } } } RF_Buffer[17] &= 0xFE; Conf

Wireless High Frequency Transceiver Module (RF GFSK)

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?