Wireless High Frequency Transceiver Module (RF GFSK)

More documents

Recommendations

Info

TRW_24G_CS = 0; TRW_24G_CE = 1; Write_TRW_24G_BYTE(0xF0); Write_TRW_24G_BYTE(0xF0); for(i=0;i
= 1 , <strong>Module</strong>s work is in the ShockBurth model . ---------------------------------------------------------------------- Void Control_TRW_24G(void) { unsigned char i,Send_Value = 0x00,Receive_Time = 0,Receive_Value=0; unsigned int Freq_buffer; Freq_buffer = <strong>RF</strong>_Status[2]
Page 1 and 2:
TRW-24G WENSHING®© V1.04 Wireless
Page 3 and 4: Specification : Conditions: VDD=+3V
Page 5 and 6: http://www.wenshing.com.tw ; http:/
Page 7 and 8: ShockBurst TM principle: When the T
Page 9 and 10: RF front end is powered up. RF pac
Page 11 and 12: Figure 4 Simultaneous 2 channel rec
Page 13 and 14: Configuration word overview: Table
Page 15 and 16: The MSB bit should be loaded first
Page 17 and 18: NOTE: An 8 bit CRC will increase th
Page 19 and 20: The data packet for both ShockBurst
Page 21 and 22: Example: ShockBurth in the receive
Page 27 and 28: 0 0 0 1 0 1 0 0 Example: In direct
Page 29 and 30: Example: In direct receive mode, it
Page 31 and 32: Example: In direct receive mode, it
Page 33 and 34: Figure 9 VDD off to active mode Not
Page 35 and 36: ShockBurst TM RX: Figure 12 Timing
Page 37 and 38: DLY_REG EQU 0X1C KEY_REG EQU 0X1B T
Page 39 and 40: IOW 0XD MOV A, @0X08 ; P5, 0- LED P
Page 41 and 42: CALL DELAY1MS MOV A, P6 AND A, @0X0
Page 43 and 44: AND A, @0X07 MOV BYTE, A JBC P5, 3
Page 45 and 46: R_RET: MOV A, @0X10 MOV 0X13, A CAL
Page 47 and 48: ;===== RF CONFIG SUBROUTINE ======
Page 49 and 50: DJZ 0X10 JMP RF_S_ADD_BYTE MOV A, @
Page 51 and 52: ;==================================
Page 53: } /* ------------------------------
Page 57: } } } } RF_Buffer[17] &= 0xFE; Conf
show all

Wireless High Frequency Transceiver Module (RF GFSK)

Create successful ePaper yourself

Delete template?

Save as template?