Mechanized Conversion Kit Installation Instructions for PC-900 - ESAB

More documents

Recommendations

Info

MECHANIZED CONVERSION KIT INSTALLATION INSTRUCTIONS 1. Access the inside of the PC-900 by unscrewing the screws and removing the cover. 2. Assemble the strain relief onto the 14 pin cable as shown and partially tighten. 3. Remove the hole plug on the top right side of the back of the unit. 6
MECHANIZED CONVERSION KIT INSTALLATION INSTRUCTIONS 4. Cut the tie wrap, unplug control transformer wires to allow for easier cable routing. 5. Thread the cable through the hole as shown and allow cable to hang loose. Add locknut and partially tighten. Add heatshrink to cable and leave loose, before applying clamp. 6. Assemble the cable clamp onto the exposed shield area and attach to the frame with the screw provided. Orient clamp downward as shown. Cable clamp Heatshrink (leave loose) 7 Cut the tie wrap here Cable clamp in postion
Page 1 and 2: Mechanized Conversion Kit Installat
Page 3 and 4: Users of ESAB welding and plasma cu
Page 5: MECHANIZED CONVERSION KIT INSTALLAT
Page 9 and 10: MECHANIZED CONVERSION KIT INSTALLAT
Page 15 and 16: REVISION HISTORY 15

Mechanized Conversion Kit Installation Instructions for PC-900 - ESAB

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?