Hotsy 558-559_0111 - ETS Company Pressure Washers and More

More documents

Recommendations

Info

TROUBLESHOOTING GUIDE SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION Burner will not ignite when trigger gun is open. ...continued Burner smokes or has obnoxious odor. Unloader cycles when trigger gun is open or closed. Defective primary regulator. Replace regulator. Defective gas valve. Replace gas valve. Stack restriction. See Venting under Installation. Air in system. Open and close trigger gun several times. Unloader out of adjustment or defective. Water leak between unloader valve and trigger gun. Call a qualified service technician to adjust or replace unloader valve. Check fittings, hose and trigger gun for leaks. Repair or replace. Pilot does not light. Gas valve closed. Set gas valve ON/OFF knob to pilot. Pilot ignites but will not stay on when ON/OFF knob is released. Gas leak in pilot. Call qualified service technician. Pilot too far away from thermocouple. Thermocouple loose at gas valve. Tighten to firm fit. Adjust thermocouple closer to flame. Short thermocouple life. Excessive heat from pilot flame. Decrease pilot supply gas. Thermocouple too close to pilot. Adjust thermocouple farther away. GFCI tripped. Device has not been reset. Follow instructions on GFCI. Defective GFCI device. Replace. Line to ground fault. Contact qualified electrician to troubleshoot for ground fault. IMPORTANT If the pressure washer demonstrates other symptoms or the corrective actions listed do not correct the problem, contact the local authorized Hotsy Service Center. The Hotsy Service Center can be identified by contacting: Customer Service Department The Hotsy Corporation 21 Inverness Way East Englewood, Colorado 80112 (303) 792-5200 Page 12 Hotsy 558-559
Hotsy 558-559 When ordering from your dealer, please provide the following: Model Number: ________________ Release:_______________ Machine Serial Number: ________________________________ Component Part Number: _______________________________ Description: __________________________________________ FOR HELP OR ADDITIONAL INFORMATION, CONTACT: Customer Service Department The Hotsy Corporation 21 Inverness Way East Englewood, CO 80112 (303) 792-5200 Page 13
Page 1 and 2: THE HOTSY CORPORATION SERIAL NUMBER
Page 3 and 4: CONTROL BOX PRESSURE HOSE ATTACHMEN
Page 5 and 6: Getting Started Hotsy 558-559 INSTA
Page 7 and 8: Before Starting Hotsy 558-559 OPERA
Page 9 and 10: 10. Small parts should be washed in
Page 11: Hotsy 558-559 TROUBLESHOOTING GUIDE
Page 15 and 16: 5, 6 4 1 2,3 1 Figure 9 - Machine A
Page 17 and 18: Figure 11 - Water Inlet Assembly Re
Page 19 and 20: 1 Figure 13 - Trigger Gun, Exploded
Page 21 and 22: 8 6,7 4,5 3 2 Figure 15 - Control B
Page 23 and 24: Figure 17 - Pump Assembly Ref. No.
Page 25 and 26: Ref. No. Part No. Description Qty.
Page 28: 784489-11-01 WARRANTY HOTSY LIMITED

Hotsy 558-559_0111 - ETS Company Pressure Washers and More

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?