Elite CSW200 Manual - Fast Access Security Corp.

32
Bolt-On
Motor
and
Pulley
#3 - N.C.
Stop
Button
Install the stop
button in a secure
accessible place.
OPTIONAL DC-1000U BACK UP
DC-1000 Unit
Wire
Harness
Option A:
In case of power failure the gate opens
automatically one time and stays open.
When power is restored the operator
returns to normal condition.
Option B:
In case of power failure the gate will not
open automatically until activated by a key
switch or push button. Maintain contact
with the switch or push button until gate is
completely open.
For More Details,
ask your Local Dealer
STOP BUTTON ALARM SHUT-OFF
OPEN STOP CLOSE
1 2 3 4 5 6
#4 - Com
W4
Omni Option Board Needed
CENTER SAFETY EXIT
QCC
W4
A B
G B A
OPEN STOP MS LINKCLOSE
MAGLOCK ALARM ARMED M/S LINK
Cut jumper wire #W4.
CENTER SAFETY EXIT
SYSTEM ON
SENSORS
This is an important command required to stop the audio alarm in case it has
been triggered. Otherwise the alarm will sound for 5 minutes and reset itself.
Use STOP Button:
•To stop the movement of the gate in case of potential entrapment.
•To reset the audio alarm, (check for obstructions).
•To stop the gate operator while traveling.
When using the Omni option board, use the “STOP” input to connect the stop button.
ALARM
SENSOR
1 3
COMMAND
PROCESSED
FIRE
DEPT.
EXIT
LOOP
1 3
REVERSE
SENSOR
STRIKE
OPEN
SAFETY
LOOP
TIMER
OFF
OPEN LEFT
RADIO
RECEIVER
CENTER
LOOP
60
3
1 3
ON
OPEN RIGHT
GATE
LOCKED
RESET
MOTOR
DC-BACKUP
POWER
OVERLOAD
OPEN
STOP
CLOSE
ALARM
SENSOR
MADE IN USA