“DIAMANT” Special Products - DIAMANT Metallplastic GmbH

New Formulation by Diamant: “UltraMetal 1250”
High Pressure Tests 20/04/2005
Material tested:
“Diamant” UltraMetal 1250, semi-fluid viscosity, applied by special procedure.
UltraMetal 1250 is now going to be tested by various Registers and Laboratories
worldwide for further evidence of its unsurpassed qualities.
Test pressure tube made from steel, 7mm thickness,
Hole sizes diameters between 4mm to 26mm,
Oil pressure manually generated, checked by a manometer.
Tests executed “Diamant” Laboratory, Moenchengladbach, Germany,
Aug. 15 – 23, 2002, by Janos Madarasi,
Tests video-taped, available on CDrom
Hole Diameter pmax Cure time at Remarks
mm bar / psi hours °C / °F
4 220 / 3,190 2 60 / 140 test stopped by small adhesion break
6 200 / 2,900 2 60 / 140 test stopped by small adhesion break
8 220 / 3,190 12 20 / 68 test stopped by small adhesion break
10 250 / 3,625 ! 12 18 / 64 test stopped by small adhesion break
12 160 / 2,320 ! 1 21 / 70 cure time too short, misprepared
14 225 / 3,263 ! 2 60 / 140 test stopped by small adhesion break
16 205 / 2,973 2 60 / 140 test stopped by small adhesion break
18 220 / 3,190 12 18 / 64 test stopped by small adhesion break
20 190 / 2,755 2 60 / 140 test stopped by long adhesion break
22 185 / 2,683 2 60 / 140 test stopped by small adhesion break
prep. not sufficient
24 175 / 2,538 12 19 / 66 test stopped by small adhesion break
prep. not sufficient
26 210 / 3,045 2 60 / 140 test stopped by small adhesion break
Innovational defect repair of pipes, tubes, containers, …
for any type of metal carrying any type of gas or liquid
now available as per latest patented procedure.
-22-