Engine Manual - Best Service

64
CHAPTER 5
Pro Edit
IMPORTANT: Some Flexible Modifiers contain additional internal modules, like LFO,
Free Envelope, Step Modulator, etc. These modules get displayed in the
right part of the Flexible Modifier Editor:
Primarily you will get a list of all basic destinations for your Flexible
Modifiers. As soon as you add a Flexible Modifier that contains an
additional internal module, the list of available destinations automatically
gets extended by this module.
Beside the internal and external sources you can also select many parameters of insert
filters and effects as destinations - available options are shown in the menu automatically.
Using this options you can change the “frequency” parameter value (destination) of a 6
band equalizer with the modwheel (source), for example.
Also possible is the assignment of changes of the “dry/wet” values of an Origami Impulse
Response Processor (destination) to the run of a Step Modulator (source). In this case the
“dry/wet” values will change according to the created Stepmodulator run.
TIP: If you use internal sources (LFO, Stepmodulator, Free Envelope, etc.) with this
function, you have to pay attention to activate or deactivate the “retrigger”
parameter of the internal sources. This parameter will define if the run of the
sequence will start from the beginning always you press a new key (retrigger “on”)
or if the run of the sequence continues (retrigger “off”).