netGateway DTM for netTAP, netBRICK and netLINK - Hilscher

Configuration Sequence for Gateway and Proxy 24/256
2.2.5 Configuration of the secondary Network
1. Configure the protocol at the secondary network (Port X3)
‣ Select from the context menu of the NT 50-XX-XX symbol the entry
Configuration > Modbus RTU
The Modbus RTU configuration window opens
Figure 10: Protocol Configuration
2. Set protocol parameter
‣ Set the parameters. To configure the device as a Modbus RTU Slave
set for Protocol Mode the value IO Slave. Set the following
important parameter: Modbus Address, Interface type, RTS
Control, Baud Rate, Stop Bits and Parity. These parameter
are important that the used Modbus RTU Master can communicate with
the gateway device.
More information about Modbus RTU parameter is in section Modbus
RTU Parameter on page 188.
3. Close the configuration window
‣ Click OK
The configuration window closes
netGateway DTM for netTAP, netBRICK and netLINK | Configuration of Gateway and Proxy Devices
DOC081201OI04EN | Revision 4 | English | 2011-03 | Released | Public © Hilscher, 2009-2011