20% - IMER USA.

COMBI 200: use and maintenance
___________________________________________________________________________________________________________________
The appendix contains the diagrams for the various units present in the
machine and the reference drawings. This section also contains the
documentation for the components installed in the machine and referred to in
the manual.
For wiring, the operator must consult the diagrams below
S1
C1
X1
PE
N
L1
M1
M2
Control switch
Capacitor
Disk motor connector
Overload line conductor
Neutral line conductor
Phase line conductor
Disk motor
Pump motor
Fig.5.1
When the start switch is pressed, the motor − No mains voltage.
does not start
− The plug and socket are not connected − Check the mains.
properly.
− The power supply cable is disconnected − Reset the correct connection.
from the cabinet.
− An electric wire inside the motor terminal − Replace the cable.
board is disconnected.
− Contact an electrician for assistance.
− An electric wire inside the cabinet is − Contact an electrician for assistance.
disconnected.
− The mains switch is faulty.
− Change the switch.
No cooling water for the disk. − Consult machine cleaning, section 4.2 ,and tank cleaning, section 4.5
The disk does not cut. − Incorrect disk rotation direction.
− Dismantle the disk and reposition it in the
direction indicated on the disk label.
− Worn disk.
− Fit a new disk.
5