MagicStream Laminar Installation and User's Guide - Pentair

26
Maintenance and Troubleshooting
The following information describes how to service and maintain the MagicStream ®
Laminar.
Filter Cleaning
Perform routine maintenance on the filter to ensure trouble-free Laminar
operation. Be careful to keep debris out of the discharge plumbing when
cleaning the filter. If debris gets into the filter discharge line to the laminar,
follow this procedure:
1. Remove the laminar by unscrewing the two deck housing lid retaining
screws.
2. Remove the deck housing lid and laminar unit and place on the deck.
3. Disconnect the supply union and turn on the Laminar supply pump until the
water runs clear.
4. Reattach the union, place the laminar back in the deck housing and check
the alignment of the stream.
5. Replace the deck housing lid retaining screws.
Clogged Laminar (Poor Stream Quality)
If the laminar orifice becomes clogged with debris, follow this procedure:
1. Remove the Laminar by unscrewing the two deck housing lid retaining
screws.
2. Remove the deck housing lid and Laminar unit and place on the deck.
Disconnect the supply union.
3. Using a garden hose, place the hose over the jet nozzle and force water
backward through the unit and out the 3/4” open union. This will clear most
of the debris.
NOTE: Do not insert anything into the laminar orifice! This may permanently
damage the laminar stream.
MAGICSTREAM ® Laminar Installation and User’s Guide