Installation (pdf) - Touratech-USA
Installation (pdf) - Touratech-USA
Installation (pdf) - Touratech-USA
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
http://www.touratech-usa.com/instl/instl_052-0014.html<br />
back to:<br />
www.touratech-usa<br />
TOURATECH<br />
Pannier set<br />
installation.<br />
part# 052-0014<br />
Use these suggestions at your own risk.<br />
(similar -0011, -0013, -<br />
0015)<br />
These instructions are new and have not been tested by independent<br />
installers.<br />
The instructions are not complete, but assist in installation.<br />
<strong>Touratech</strong> and <strong>Touratech</strong>-<strong>USA</strong> assume no responsibility for errors using<br />
these suggestions.<br />
If you have any doubts about your ability to install the pannier set, please<br />
contact a professional installer.<br />
email the webmaster<br />
Synopsis<br />
The Pannier set is<br />
attached to the rear<br />
frame using the two<br />
upper BMW pannier<br />
mount holes, and braced<br />
at the passenger footrest.<br />
There is a rear<br />
crossmember.<br />
1) Remove the BMW<br />
pannier supports, if<br />
equipped.<br />
2) Remove the left side<br />
passenger footrest<br />
completely.<br />
3) Remove only one<br />
rearmost M8 bolt from<br />
the right passenger<br />
footrest.<br />
4) Install the racks.<br />
5) Re-install the left<br />
side passenger footrest.<br />
6) Install the small<br />
blinkers (special set<br />
only).<br />
7) Install the panniers<br />
onto the racks.
Location of hardware on R1150GS, left side.<br />
Location of hardware on R1150GS, right side.<br />
Left side (exhaust side) brace at passenger-peg.<br />
Photo is LOOKING UP from below.<br />
Note the pannier rack goes between the<br />
passenger footrest and the BMW frame. Three<br />
M8 washers make up for the thickness of the<br />
pannier rack between the footrest and the frame.<br />
RIGHT side brace at passenger-peg. Photo is<br />
LOOKING UP from below.<br />
Note the pannier rack goes on the inside of the<br />
BMW frame, and is secured with the M8 nyloc<br />
nut.
On the "Special set" which has a welded cutout<br />
to match the BMW exhaust, there is an exhaust<br />
extension.<br />
Inset shows the attachment of the rear crossbrace<br />
on the rear side of the tab.<br />
http://www.touratech-usa.com/instl/instl_052-0014.html