AT Commands Set

SIM5320 AT Command Set
11 – 200000 (~0.44 kbit/s)
12 – 500000 (~1.11 kbit/s)
13 – 1000000 (~2.2 kbit/s)
14 – 2000000 (~4.4 kbit/s)
15 – 5000000 (~11.1 kbit/s)
16 – 10000000 (~22 kbit/s)
17 – 20000000 (~44 kbit/s)
18 – 50000000 (~111 kbit/s)
31 – optimization
Examples
AT+CGQREQ?
+CGQREQ:
OK
AT+CGQREQ=?
+CGQREQ: "IP",(0-3),(0-4),(0-5),(0-9),(0-18,31)
+CGQREQ: "PPP",(0-3),(0-4),(0-5),(0-9),(0-18,31)
+CGQREQ: "IPV6",(0-3),(0-4),(0-5),(0-9),(0-18,31)
OK
15.5 AT+CGEQREQ 3G quality of service profile (requested)
Description
The test command returns values supported as a compound value.
The read command returns the current settings for each defined context for which a QOS was
explicitly specified.
The write command allows the TE to specify a Quality of Service Profile for the context identified
by the context identification parameter which is used when the MT sends an Activate PDP
Context Request message to the network.
A special form of the write command,AT+CGEQREQ= causes the requested profile for
context number to become undefined.
SIM PIN References
YES 3GPP TS 27.007
Syntax
Test Command
Responses
SIM5320_ATC_V1.24 281
8/14/2012