Nanometrics Data Formats Reference Guide

Chapter 2: NMX Alert Format
where
arg1 = elapsed time since NaqsServer was last started
arg2 = number of packets received in past 24 hours (or since startup)
arg3 = percentage of packets received which were retransmitted packets
arg4 = number of instruments from which packets were received in past 24 hours
arg5 = total number of instruments in NaqsServer configuration
arg6 = list of stations from which packets were received in the past 24 hours
arg7 = list of stations from which NO packets were received in the past 24 hours
2.3.2.4 RbfOpenFail
2.3.2.5 RbfWriteFail
2.3.2.6 RbfWriteOk
This message is issued if one or more ringbuffers cannot be opened properly when
NaqsServer starts up.
sourceID NaqsServer (or configured ID)
classID RbfOpenFail
format string File open failed on %1 / %2 ringbuffers. See Naqs log.
arguments /arg1/arg2
where arg1 = number of ringbuffers which could not be opened
arg2 = number of ringbuffers which NaqsServer attempted to open
This message is issued when there is an error writing to a ringbuffer.
sourceID NaqsServer (or configured ID)
classID RbfWriteFail
format string Ringbuffer write failure on %1, rc = %2, count = %p.
arguments /arg1/arg2
where arg1 = name of channel for which write failed
arg2 = integer error code from program
This message is issued when a ringbuffer write succeeds after previously being failed.
sourceID NaqsServer (or configured ID)
classID RbfWriteOk
format string Ringuffer write succeeded on %1 after %p failures.
arguments /arg1
where arg1 = name of channel
2.3.2.7 InstrumentOffline
This message is issued when Naqs has not received any data for 10 minutes from one
or more instruments that were previously online.
sourceID NaqsServer (or configured ID)
classID InstrumentOffline
format string NaqsServer has stopped receiving from %1%r\
Currently receiving from %2 / %3 instruments %r\
14602R4
Nanometrics Data Formats
2003-11-07 Reference Guide
27