Wiring Diagram of 6A - Lextreme.com

More documents

Recommendations

Info

10 INSTALLATION INSTRUCTIONS 5. Tap the White wire to ground several times. Each time you pull the wire from ground, a spark should jump from the coil wire to ground. If spark is present, the ignition is working properly. If there is no spark skip to step 6 below: If triggering with the Magnetic Pickup: MAGNETIC PICKUP TRIGGER 1. Make sure the ignition switch is in the "Off" position. 2. Remove the coil wire from the distributor cap and set the terminal approximately 1/2" from ground. 3. Disconnect the MSD magnetic pickup wires from the distributor. 4. Turn the ignition to the On position. Do not Figure 9 Checking for Spark with Magnetic crank the engine. Pickup. 5. With a small jumper wire, short the MSD's Green and Violet magnetic pickup wires together. Each time you break this short, a spark should jump from the coil wire to ground. If spark is present, the ignition is working properly. If there is no spark skip to step 6 below: 6. If there is no spark: A. Inspect all of the wiring. B. Substitute another coil and repeat the test. If there is now spark, the coil is at fault. C. If there is still no spark, check to make sure there is 12 volts on the small Red wire from the MSD when the key is in the On position. If 12 volts is not present, find another switched 12 volt source and repeat the test. D. If, after following the test procedures and inspecting all of the wiring, there is still no spark, the MSD Ignition is in need of repair. See the Warranty and Service section for information. The following wiring diagrams illustrate numerous installations on different vehicles and applications. If you experience difficulties when installing your MSD, contact our Customer Support Department at (915) 855-7123 (8 - 5 Mountain time) or e-mail us at: msdtech@msdignition.com MSD SYSTEMS Installing to Points/Amplifier Style Ignition. NOTE: On dual point setups, it is recommended to remove the trailing set of points. NOTE: Ballast Resistor is not necessary. AUTOTRONIC CONTROLS CORPORATION • 1490 HENRY BRENNAN DR., EL PASO, TEXAS 79936 • (915) 857-5200 • FAX (915) 857-3344
INSTALLATION INSTRUCTIONS 11 MSD SYSTEMS Installing to an MSD Distributor/Crank Trigger. MSD SYSTEMS Installing to an MSD Distributor PN 8360. NOTE: The ignition module of the PN 8360 still triggers the MSD. AUTOTRONIC CONTROLS CORPORATION • 1490 HENRY BRENNAN DR., EL PASO, TEXAS 79936 • (915) 857-5200 • FAX (915) 857-3344
Page 1 and 2: MSD 6 Series Installation Instructi
Page 3 and 4: INSTALLATION INSTRUCTIONS 3 Routing
Page 5 and 6: INSTALLATION INSTRUCTIONS 5 Grounds
Page 7 and 8: INSTALLATION INSTRUCTIONS 7 TROUBLE
Page 9: INSTALLATION INSTRUCTIONS 9 Most ot
Page 13 and 14: INSTALLATION INSTRUCTIONS 13 MSD SY
Page 15 and 16: INSTALLATION INSTRUCTIONS 15 GM IGN
Page 17 and 18: INSTALLATION INSTRUCTIONS 17 GM IGN
Page 19 and 20: INSTALLATION INSTRUCTIONS 19 FORD I
Page 21 and 22: INSTALLATION INSTRUCTIONS 21 CHRYSL
Page 23 and 24: INSTALLATION INSTRUCTIONS 23 AFTERM

Wiring Diagram of 6A - Lextreme.com

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?