features - WES Components

As a true online double conversion UPS the Centurion RT is
our highest density UPS. Boasting an output power factor
of 0.9, this will fully protect mission critical devices as it can
support larger loads than UPS products of an equal VA
rating.
The Centurion RT has an energy saving ECO mode, which
allows the unit to operate at very high efficiency, up to
98%. When the utility mains input voltage is within the ECO
range the UPS saves energy by passing the mains supply
directly through to the load, using the inverter
intermittently.
The Centurion RT incorporates hot-swappable internal
battery packs which can be accessed via the front panel
for maintenance changes, keeping the UPS operational
during battery replacement. Battery backup time can be
increased by simply adding additional Battery Banks.
The LCD display panel is readily viewable whether the UPS
is horizontal or vertical. The display Menu is simple and
intuitive. It displays all critical and noncritical parameters,
including the estimated battery backup time remaining.
This UPS comes with programmable power management
outlets allowing the user to control load segments,
therefore extending battery backup times to mission
critical devices by shutting down noncritical items.
Centurion RT
features
• True double-conversion
• Output power factor 0.9
• User-friendly and easy-shift LCD display
• Rack or Tower design
• ECO and advanced ECO mode for energy saving
• Output voltage regulation ± 1%
• Generator compatible
• Programmable power management outlets
• Emergency Power Off function (EPO)
• Hot swappable battery design
• Available in 1000, 2000 and 3000 VA models
• Ideal for medium density power protection
• USB, RS232, SNMP and AS400 multiple communications
available
The Centurion RT addresses the real market need of our
clients: to develop True Online Double Conversion UPS
products that can be used interchangeably in either tower
or rackmount form factors, has ECO mode capability, with
extendable battery backup times that can be easily
increased, programmable outlets
and with a front panel LCD that displays
crucial information to the user.
THE AUSTRALIAN UPS COMPANY
www.powershield.com.au

Centurion RT
BATTERY BANKS
Model LSCERT1000S PSCERT2000S PSCERT3000 PSCRTBB8
PSCRTBB12
Capacity VA 1000 VA 2000 VA 3000 VA
Suits PSCERT2000S
Suits PSCERT3000
W 900 W 1800 W 2700 W
INPUT
Voltage
Range
Low Line Transfer 160 Vac / 140 Vac / 120 Vac / 110 Vac ± 5 %
(based on load percentage 100%-80% / 80%-70% / 70%-60% / 60%-0)
Low Line Comeback 170 Vac / 150 Vac / 130 Vac / 120 Vac ± 5 %
High Line Transfer 300 Vac ± 5 %
High Line Comeback 290 Vac ± 5 %
Frequency Range
40Hz - 70Hz
Phase
Single phase with ground
Power Factor Correction 0.99 @ nominal voltage (100% load)
OUTPUT
Power Factor
0.9
Output Voltage
AC Voltage Regulation (Batt. Mode)
Frequency Range (Synchronized Range)
Frequency Range (Batt. Mode)
Load Crest Factor
240Vac (User selectable 208/220/230/240 Vac)
± 1%
47 - 53 Hz or 57 - 63 Hz
50 Hz ±0.5 % or 60Hz ± 0.5%
5:1 (max.)
Harmonic Distortion 2 % THD (Linear Load) ; 8% THD max. (Non Linear Load) (Batt. mode before shut down)
Transfer Line mode to battery mode
Zero
Time Inverter to Bypass
4 ms (Typical)
Waveform (Batt. Mode)
Pure Sinewave
EFFICIENCY
AC Mode 88% 90%
Battery Mode 86% 88%
Battery
Battery Type 12 V / 9 Ah 12 V / 9 Ah 12 V / 9 Ah 12 V / 9Ah 12 V / 9 Ah
Numbers 2 4 6 8 12
Typical Recharge Time
4 hours recover to 90% capacity (for standard model only)
Charging Current (max.) 1A 1A 1A
Charging Voltage 27.4 Vdc ± 1% 54.7 Vdc ±1% 82.1 Vdc ±1%
INDICATORS
LCD Display
UPS status, Load level, Battery level, Input/Output Voltage,
Battery Time Remaining and Fault indicators
ALARM
Battery Mode
2 beeps every 30 seconds
Bypass Mode
1 beep every 10 seconds
Low Battery
Rapid one beep every second
Overload
2 short beeps every 2 seconds
Fault
Continously sounding
PHYSICAL
Dimension, D x W x H (mm) 380 x 438 x 88 480 x 438 x 88 600 x 438 x 88
Net Weight (kgs) 12.9 20.6 28
ENVIRONMENT
Humidity
20-90 % RH @ 0-40°C (non-condensing)
Noise Level
Less than 50dBA @ 1 Meter
MANAGEMENT
Smart RS232
USB
Optional PSSNMP
Optional PSAS400
PowerShield NetGuard Software - Supports Windows ® 2000/2003/XP/Vista/2008,
Windows ® 7, Linux, Unix, and MAC
Power management from SNMP manager and web browser (Intelligent Slot)
AS400 dry contact communication card (Intelligent Slot)
PSCERT1000S
PSCERT2000S PSCERT3000
PSCRTBB8
Suits PSCERT2000S
PSCRTBB12
Suits PSCERT3000
* Product specifications are subject to change without further notice
www.powershield.com.au