Technical Guide STEICO construction

More documents

Recommendations

Info

Walls | Wall Applications STEICOwall is a slender, efficient building element for wall constructions that demand a high level of both energy efficiency and strength. Using pre-insulated STEICOwall studs facilitates easy insulation of the structure and thereby contributes to overall cost savings. 34 Technical Guide STEICO construction
STEICOwall for walls Characteristic axial compression loads for sTEICOwall To EC 5 Type STEICO wall SW 45 STEICO wall SW 60 STEICO wall SW 90 Flange b * h [mm] With one side only sheathed a) N k [kN] With both sides sheathed a) N k [kN] 45 * 45 6.1 55.5 60 * 45 14.2 74.9 90 * 45 45.0 124.9 Note: The above tables are based on a wall panel height of 2,5 m. Sheathing to the requirements of BS 5268 to provide lateral restraint to the flanges and it is recommended that in all construction this is provided to both sides of the stud. Where the studs are part of a system offering lateral restraint to a structure, a minimum of 1 layer of category 1 or 2 sheathing must be provided. Where wind reversal occurs, both faces must be sheathed to prevent buckling. Characteristic Load on the Support According to EC 5 For Solid Timber C 16, C 24 and Glulam GL 28 b) Type Flange b * h [mm] Characteristic load per stud in kN a) C 16 C 24 GL 28 C 16 C 24 GL 28 C 16 C 24 GL 28 STEICO wall SW 45 STEICO wall SW 60 STEICO wall SW 90 45 * 45 25.1 28.5 30.8 22.5 25.6 27.6 22.5 25.6 27.6 60 * 45 30.9 35.1 37.9 28.3 32.2 34.7 28.3 32.2 34.7 90 * 45 41.3 47.0 50.7 38.8 44.0 47.6 38.8 44.0 47.6 a) The design values have to be calculated in the following way: N d = N k * k mod / γ m where: N k tabular value, k mod modification factor, γ m partial factor for material properties b) For sole plate / top plate of 43 mm height Calculation Assumptions: • Load discharge takes place in the middle of the joist • Even load distribution on both flanges Technical Guide STEICO construction 35
Page 1 and 2: Technical Guide STEICO construction
Page 3 and 4: Welcome | CONTENTS Introduction 4 I
Page 5 and 6: Welcome Following nature’s steps:
Page 7 and 8: Product Overview | A product for ev
Page 9 and 10: Properties Properties | Material pr
Page 11 and 12: Properties Characteristic bearing v
Page 13 and 14: Properties | Permissible design pro
Page 15 and 16: Kolumnentitel Properties | Web stif
Page 17 and 18: Floors STEICOjoist for floors | Flo
Page 19 and 20: STEICOjoist for floors G + Q Maximu
Page 21 and 22: STEICOjoist for floors TF1 Rim Boar
Page 23 and 24: STEICOjoist for floors | Masonry De
Page 25 and 26: STEICOjoist for floors | General De
Page 27 and 28: Roofs STEICOjoist for roofs | Roof
Page 29 and 30: STEICOjoist for roofs | Span Tables
Page 31 and 32: STEICOjoist for roofs R1a Ridge bea
Page 33: STEICOjoist for roofs R9a Gable lad
Page 37 and 38: STEICOwall for walls | Thermal insu
Page 39 and 40: General information Installation, S

Technical Guide STEICO construction

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?