Kraftfahrt-Bundesamt - Falcom

BOLERO-LT Hardware Description Version 1.0.0
� Casing :
� Certifications :
� Directive :
� Firmware :
� Memory :
� Serial ports :
� Serial Interface Setting :
� Evaluation kit :
4.1.1 Power consumption
To be defined.
➢ Fully shielded
➢ Fully type approved confirming with R&TTE directive.
➢ CE, FCC, PTCRB, e1,IC.
➢ RoHS compliant.
4.1.2 Operating temperatures
➢ Embedded TCP/IP stack (inc. TCP, IP and SMTP
protocol),
➢ Accessible via PFAL commands,
➢ Upgradeable via serial port and remotely over the air
(GPRS/TCP interface).
➢ 2 Mbyte FLASH for configuration, data-logging and
firmware storage
➢ 1 x full duplex serial communication
➢ Full duplex serial communication, CMOS level
➢ 2-wires (1 x Rx and 1 x Tx) for serial communication
➢ Baud rate on the serial port (user configuration).
➢ 8 data bits, no parity, 1 stop bit, no flow control.
➢ The BOLERO-LT Evalkit is designed to test, evaluate
and make basis configuration to enable remote
monitoring/configuration of the FALCOM BOLERO-LT. It
provides a sample configuration for application.
Parameter Min. Typ. Max. Unit
Storage temperature (without internal battery) -40 +25 +90 °C
Operating temperature (without internal battery) -40 +25 +85 °C
GSM* (without internal battery) -30 +25 +80 °C
Charging temperature (with internal battery enabled ***) 0 +25 +45 °C
Discharging temperature (with internal battery enabled ***) -20 +25 +60 °C
* The extreme temperature can affect the sensitivity and performance of the GSM engine.
** Using configuration $PFAL,Cnf.Set,DEVICE.BAT.MODE=disabled
*** Using configuration $PFAL,Cnf.Set,DEVICE.BAT.MODE=auto
Table 2: Operating temperature
This confidential document is a property of FALCOM and may not be copied or circulated without previous permission.
Page 16