31.10.2012 Views

FALCOM NAVI-XS POI

FALCOM NAVI-XS POI

FALCOM NAVI-XS POI

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

<strong>NAVI</strong>-<strong>XS</strong> <strong>POI</strong> USER’S GUIDE VERSION 1.00<br />

Middle LED (red / green) Continued<br />

Battery (green)<br />

Blinking Green (0.5 s ON / 0.5 s<br />

Off)<br />

Blinking Green (0.5 s ON / 1.5 s<br />

Off)<br />

Blinking Green (0.5 s ON / 2.5 s<br />

Off)<br />

Right LED (blue), Bluetooth status optical indicator<br />

Bluetooth (blue)<br />

Blinking<br />

Continually lights<br />

Table 4: Coding of the status LEDs.<br />

When the charger is still connected - batteries may be in charging<br />

phase.<br />

When batteries are fully charged and the charger is disconnected<br />

from the unit.<br />

Indicates that the device is switched on.<br />

When the equipment is ready for a Bluetooth connection (no<br />

Bluetooth connection available).<br />

When the Bluetooth connection between devices is now<br />

established.<br />

NOTE: The Bluetooth module inside the <strong>NAVI</strong>-<strong>XS</strong> <strong>POI</strong> will be powered off<br />

without any warning, if for longer than 5 minutes no Bluetooth<br />

connection between the <strong>NAVI</strong>-<strong>XS</strong> <strong>POI</strong> and the host device is available<br />

(feature of power saving). To turn the Bluetooth module on again,<br />

shortly press either ON or OF button and then perform a Bluetooth<br />

connection.<br />

2.3.3 Power jack<br />

In order to recharge the internal batteries (only rechargeable batteries), the Ø 3,5<br />

mm power jack allows you to connect either a car adapter cable (KA-<strong>NAVI</strong>-<strong>XS</strong> <strong>POI</strong>-<br />

PS) or a power charger (PS-003) to a DC electrical outlet. Both accessories are<br />

available upon request (refer to the chapter 0.2.1 for more details).<br />

2.3.3.1 Charging & Discharging the included batteries<br />

Your <strong>NAVI</strong>-<strong>XS</strong> <strong>POI</strong> is powered by two rechargeable batteries, an alarm will warn you<br />

when the batteries reach the low level.<br />

IF YOU ARE USING NON-RECHARGEABLE BATTERIES, DO NOT ATTEMPT TO CHARGE THEM.<br />

Once the batteries are clipped in the <strong>NAVI</strong>-<strong>XS</strong> <strong>POI</strong>, plug one of the cable charger<br />

(not supplied with <strong>NAVI</strong>-<strong>XS</strong> <strong>POI</strong>, however, available upon request, see chapter 0.2),<br />

into the corresponding power jack interface of <strong>NAVI</strong>-<strong>XS</strong> <strong>POI</strong>. Plug the transformer unit<br />

into a main AC power socket or vehicle power outlet (it depend on the purchased<br />

cable charger, see chapter 0.2) with easy access. As far as the temperature limits is<br />

recognised, please refer to the table 3 in chapter 2.2.1.14.<br />

The extreme temperatures have an unfavourable influence on the rechargeable<br />

batteries. The capacity and life cycle of the batteries are reduced if they are kept at<br />

cold or warm places, e.g. in a closed car at summer or winter conditions. Try always<br />

to keep the included batteries at normal temperatures between 15°C and 25°C. The<br />

GPS receiver with too cold or too warm batteries does not temporarily operate<br />

sometimes, even if the batteries are completely charged. Especially, the<br />

achievement of batteries is strongly reduced at temperatures under the freezing<br />

point.<br />

During the charging time the middle LED indicator on the topside of <strong>NAVI</strong>-<strong>XS</strong> <strong>POI</strong><br />

flashes green, see also table 4. Charging will be terminated after the batteries reach<br />

full capacity (800 mA/h), which approximately takes 2-3 hours. During this time the<br />

<strong>NAVI</strong>-<strong>XS</strong> <strong>POI</strong> can also be used.<br />

Keeping the cable charger plugged to the equipment, when the batteries are fully<br />

charged, does not damage the batteries. To optimise batteries capacity, you should<br />

allow the batteries to discharge them fully. If you do not intend to use your <strong>NAVI</strong>-<strong>XS</strong><br />

<strong>POI</strong> for several days, we recommend you to remove the batteries.<br />

This confidential document is a property of <strong>FALCOM</strong> GmbH and may not be copied or circulated without previous permission.<br />

Page 13

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!