CONSTRUCTOPEDIA

More documents

Recommendations

Info

Building Instructions: Front End Setups Step# 1 Attach the hole sections of the perpendicular connector pieces to the NXT using pins. Make sure the axle holes face horizontally. Insert a 4-axle into the perpendicular connector pieces and fasten it in place with two ½ bushes. Step# 2 Fasten two curved beams to a 7-beam using extended pins. This is the sliding piece. Center for Engineering Educational Outreach, Tufts University Copyright 2007 LEGOengineering.com & Tufts Center for Engineering Educational Outreach
Building Instructions: Front End Setups Step# 3 Take one of the ½ bushes off the axle and pull the axle out. Slide it back in, inserting it through the setup from step two. Replace the bush on the axle. Center for Engineering Educational Outreach, Tufts University Copyright 2007 LEGOengineering.com & Tufts Center for Engineering Educational Outreach
Page 1 and 2: CONSTRUCTOPEDIA NXT Kit 9797 Beta V
Page 3 and 4: Building Instructions: Simple Shape
Page 5 and 6: Building Instructions: Simple Shape
Page 7 and 8: Building Instructions: Ways to Atta
Page 37 and 38: Building Instructions: Front End Se
Page 45: Building Instructions: Front End Se
Page 51 and 52: Building Instructions: 15 Minute Bu
Page 63 and 64: Building Instructions: Full Car Mod
Page 65: Building Instructions: Full Car Mod

CONSTRUCTOPEDIA

Create successful ePaper yourself

Delete template?

Save as template?