Flat suction cups - pge

Automatic Closing Valves
without Leakage Loss
Energy is expensive!
With our automatic closing valves "without leakage loss", we help you to save energy and money.
The closing valves of this series work without leakage loss and have also shown good results under dusty and dirty
condition (such as in wood working). The valves are adjusted by the manufacturer, but can be regulated in special cases.
They can also be retrofitted.
Important! The closing valves of this series only work when vacuum is
applied after the cup has touched the workpiece.
1. Put on the cup
2. Turn on the vacuum (ca. 1 - 2 seconds)
3. Lift the part
G 1/8”
6
32
for Art. No. 63.046 and
63.004-63.005-63.006-63.007
Required suction
capacity (per cup)
with adjustment by works
4 m³/h
6 m³/h
8 m³/h
Material: Alu,
For cup Ø
to Ø 150 mm
to Ø 250 mm
to Ø 360 mm
Example: 15 cups Ø 220 mm
1 5 x 6 = 9 0 m ³/h
Thus, vacuum pump with a suction
capacity of 90 m³/h is required..
When using a vacuum reservoir, that value
is halved. In that case 15 x 3 = 45 m³/h
(size of the vacuum reservoir upon
request).
Art. No. 63.046
SW 13
G 1/4"
SW 20
59
14
8
G 1/8”
G 3/8"
G 1/4"
G 1/4"
G 3/8"
SW 20
SW 20
14
45
59
15
14
G 1/4"
14
12
Art. No. 63.004 Art. No. 63.005
Art. No. 63.006
G 1/4"
G 1/8" G 1/4”
G 3/8"
Art. No. 63.007
®
14 12
59
SW 20
FIPA GmbH
VAKUUM-TECHNIK
9
15
41
G 1/4" G 1/4"
SW 17
Art. No. 63.017 Art. No. 63.018
D-85737 Ismaning Tel. +49/(0)89 / 96 24 89 -0
Freisinger Str. 30 Fax +49/(0)89 / 96 24 89-11
www.fipa-online.com e-mail: info@fipa-online.com
7.2E
9
15
41
SW 17
for Art. No. 63.017 + 63.018
Required minimum
suction capacity
Maximum cup Ø
(recommended)
for bellows cup Ø
1,74 m³/h
75 mm
33 mm
3/2005