3UF5 SIMOCODE-DP System Motor Protection and Control Device

Connection of a thermistor sensor circuit
for optional thermistor-type motor
Connection of a summation current
transformer for earth fault monitoring
Connection of control
supply voltage
- 24 V DC
- 115 V AC
- 230 V AC
3 LED displays
Device test, manual reset
- Automatic reset parameterisable
- Remote reset via bus or input
3 + 1 relay outputs:
- Function assignment
parameterizable
System interface
- Connection to basic unit
- Power supply from basic unit
3 + 1 outputs:
- Function assignment
parameterisable
2 status LEDs
3 LED displays
Function assignment
parameterisable
Device test
Manual reset
A1 A2 T1 T2 1 2 3 4 5
AC 230V I1 I2 I3 I4 24VDC
G/9520
Ready
Bus
Gen. Fault
25...100A
Test/
Reset
PROFIBUS-DP
3UF5021-3AJ00-1
01 02 03 03 PROFIBUS-DP
Sys.
3UFS
6 7 8 9 10 11 B A SPE/PE
20 21 22 23 24 25 26 27 28
15 16 17 18 19 10 11 12
Sys.
3UFS
G/9520
05 06 07 08
Sys.
3UFS
3UF5100-0XX00-0AA0
30 31 32 33 34 35 PE
Ready
Gen. Fault
Test/
Reset
4 optocoupled inputs:
- 24 V DC, internally supplied
- Function assignment
parameterisable
System interface
- Connection of extension
module, operating module,
manual operating device or PC
PROFIBUS-DP bus connection
- Standard 9-pole SUB-D socket
- Terminals, e.g. for drawout unit
design
8 optocupled inputs:
- 24 V DC, 115 V AC
230 V AC, externally supplied
- Function assignment
parameterisable
System interface
- Connection of
operating module,
manual operating device
or PC
3 buttons,
function assignment
parameterisable
3 LED displays
function assignment
parameterisable
9-pole SUB-D socket
for the connection of the
manual operating device
or PC
3WX36 manual operating device
This can be connected to the basic
unit, to the extension module or to the
operating module. For commisioning,
diagnostics and maintenance. Manual
control (ON, OFF, ...) Diagnosis
(Current display, fault, ...)
Parameterisation (address,
baud rate, set current, control
function, ...)
OM-SIMOCODE-DP
STEP 7-Object-Manager to call Win-
SIMOCODE-DP/Professional in STEP 7
Connection cables with plugs
Connection between basic unit,
extension module or operating
module.
Bus terminal/bus termination
modules
If the PROFIBUS-DP is connected to
the basic unit, the standard 9-pole Sub-
D plugs with built-in bus terminating
resistor can be used. Especially for the
application of SIMOCODE-DP in Motor
Control Centers (MCC drawout unit
design) there is a bus termination
module with built-in power supply. This
guarantees that even the last unit in
the bus can be removed without any
impairment of the data flow.
Operating manual
A manual for the SIMOCODE-DP
system is available which describes
each detail of the functionality of
SIMOCODE-DP. It is intended as an aid
for project planning and system startup
and it features a comprehensive
description of the PROFIBUS-DP
communications interface and project
examples.
15