Instruction Manual - Camon

Place the power cord in the wire holders down the side.
tube or water flow could be reduced.
D) Align the filter pack (Number 5) into the corner slots and press down into the water chamber. Use the correct slot and
do not use excessive force.
E) Feed the power wire through the square hole in the
back of the water tank stand (Number 2). Make sure the
power wire is secured by the wire holders on the side of
the water bowl.
F) Then carefully slide the water bowl into the water tank
stand gently pulling the power wire out the back of the
water tank stand. Make sure all the wire comes out the
back.
G) Screw cap (Number 8) into unit (Number 6) with a
gentle, turning motion. Do not apply excessive pressure on
the cap as this may damage the incorporated gasket (7).
H) With the black water outlet on the water tank pointing
to the hole, insert water tank into the water tank stand
I) Assemble the mushroom head (Number 12) onto the
mushroom stand
2
J) Connect AC Adaptor (Number 16) to the timer unit
(Number 17) the to the water pump (Number 4). If you
do not want to use the timer you can remove it.