Instruction Manual - Camon
Instruction Manual - Camon
Instruction Manual - Camon
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Operation<br />
1) Make sure the AC adaptor is disconnected from the wall outlet<br />
2) Fill the water bowl (Number 3) until half full.<br />
3) Unscrew the black water outlet, fill the water tank as much as you want. Tighten the black water outlet when<br />
finished. Don’t forget the rubber gasket… Do not over tighten !!!<br />
Note:<br />
a) Only unscrew the large cap from the water tank when you need get inside the tank for cleaning. Make sure this<br />
large cap is screwed on tight when replacing. Do not forget the Rubber Gasket !<br />
b) For regular water filling, use the small black water outlet.<br />
4) Water will now flow from the tank into the bowl until the water reaches the factory preset level.<br />
5) Plug the AC adaptor into the wall outlet. The pump should start and water will come out from the nozzle or from the<br />
mushroom head. If you have problems check your connections.<br />
6) Check the position of the Timer Switch (Number 18) on the timer unit. Slide the switch to 30min to turn the pump<br />
ON for 30 minutes and OFF for 30 minutes repeatedly. Or slide the switch to 60min to turn the pump ON for 60<br />
minutes and OFF for 60 minutes repeatedly.<br />
Or you many side the switch to the OFF position to turn off the pump. It is recommended to unplug the transformer<br />
if the water fountain will not be used for long periods.<br />
7) Water flow speed can be adjusted by sliding the small window located on the pumps side next to where the water<br />
comes out.<br />
a) remove the water tank<br />
b) pull the water bowl away from the base slowly until the pump can be reached<br />
c) With water still in the bowl, turn the pump ON and side the small window left or right to adjust the water flow<br />
Optional Water Nozzle<br />
Dogs and larger pets will probably prefer that you remove the mushroom water fall and replace it with the included water<br />
nozzle.<br />
Installing the Optional Water Nozzles<br />
1) Remove the mushroom and its base. You must also separate the clear tube by unplugging the 90 degree fitting<br />
that plugs into the bottom of the mushroom base.<br />
2) Separate the 2 clear tubes at the black union (Number 11) taking away the black union and the short length of<br />
clear tube.<br />
3) Slip the male end of the nozzle into the longest length of clear tube that connects to the water pump.<br />
4) Turn on the pump and adjust the water stream by razing or lowering the black lever (Number 23) which the<br />
Spray Nozzle, assembled<br />
Fountain Nozzle with spray cover removed<br />
clear tube passes through.<br />
3