steppii-55/56-lt - Falcom
steppii-55/56-lt - Falcom
steppii-55/56-lt - Falcom
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
STEPPII-<strong>55</strong>/<strong>56</strong>-LT HARDWARE DESCRIPTION VERSION 1.01<br />
� Depending on the configuration, the device exchanges data with a<br />
server application (e.g. Mapping-Software, etc.). STEPPII-<strong>55</strong>/<strong>56</strong>-LT can be<br />
configured by the user via local RS232-interface or remotely over the<br />
GSM (air link see diagram marked �). This configuration is based on the<br />
STEPPII-<strong>55</strong>/<strong>56</strong>-LT operating with firmware version 1.6.2. Please, refer to the<br />
issued manual “stepp_II_software_1.6.2_manual.pdf”.<br />
� STEPPII-<strong>55</strong>/<strong>56</strong>-LT terminal supports also a firmware that uses TCP/IP stack<br />
and PPP protocol. It is an independent-customized software that<br />
provides even greater performance and flexibility for its users and system<br />
integrators to develop high-performance applications. The concept of<br />
the device is based on a simple implementation for a wide range of<br />
applications with low costs and high flexibility. The software enables you<br />
to implement applications, to track, control and monitor STEPPII-<strong>55</strong>/<strong>56</strong>-LT<br />
devices, as well as to set and poll the configuration remotely via SMS,<br />
data call or over Internet form a remote server. The software comprises<br />
a set of word-like commands termed “PFAL”. Each of these causes the<br />
terminal STEPPII-<strong>55</strong>/<strong>56</strong>-LT either to take a particular action or to read, set<br />
a particular configuration. The software provides the basic configuration<br />
settings needed when the system starts up and used as starting points for<br />
the creation of user applications. The development of user applications<br />
is based on the advanced event-handling features provided by the<br />
operating software. Events may be individually configured to be sent<br />
back GPS position data or any other information. The exact point at<br />
which you configure the STEPPII-<strong>55</strong>/<strong>56</strong>-LT depends on the application<br />
you want to develope. Events are triggered automatically at system runtime<br />
and manually when an input changes. For more information,<br />
please refer to the manual “stepp_II_software_2.4.xx_manual.pdf”.<br />
This confidential document is a property of FALCOM and may not be copied or circulated without previous permission.<br />
Page 26