02.07.2014 Views

GM Owner Manuals - Buick

GM Owner Manuals - Buick

GM Owner Manuals - Buick

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

Arming with the RKE Transmitter<br />

The alarm system will arm when the RKE transmitter is<br />

used to lock the doors after the key is removed from<br />

the ignition. The red light, if your vehicle has one,<br />

will come on to indicate that the system is arming. After<br />

all doors are closed and locked, and after a time<br />

delay, the red light, if your vehicle has one, will begin<br />

flashing at a very slow rate to show the system is armed.<br />

Arming Confirmation<br />

Your vehicle may have a red light located on top of the<br />

instrument panel, towards the center of the vehicle<br />

and near the windshield, that will flash slowly to confirm<br />

when the system is armed.<br />

Disarming with the RKE Transmitter<br />

The alarm system will disarm when the RKE transmitter<br />

is used to unlock the doors. The red light, if your<br />

vehicle has one, will go out to show that the system is<br />

disarmed.<br />

Disarming with Your Key<br />

The alarm system will disarm when the key is used to<br />

unlock the doors. The red light, if your vehicle has<br />

one, will stop flashing when the system is disarmed. If<br />

you would like the key to disarm the alarm system,<br />

see “CONTENT THEFT” under DIC Vehicle<br />

Personalization on page 3-74 for more information.<br />

PASS-Key ® III Electronic<br />

Immobilizer<br />

Your PASS-Key III system operates on a radio<br />

frequency subject to Federal Communications<br />

Commission (FCC) Rules and with Industry Canada.<br />

This device complies with Part 15 of the FCC Rules.<br />

Operation is subject to the following two conditions:<br />

1. This device may not cause harmful interference.<br />

2. This device must accept any interference received,<br />

including interference that may cause undesired<br />

operation.<br />

This device complies with RSS-210 of Industry Canada.<br />

Operation is subject to the following two conditions:<br />

1. This device may not cause interference.<br />

2. This device must accept any interference received,<br />

including interference that may cause undesired<br />

operation of the device.<br />

Changes or modifications to this system by other than<br />

an authorized service facility could void authorization to<br />

use this equipment.<br />

PASS-Key III uses a radio frequency transponder in the<br />

key that matches a decoder in your vehicle.<br />

2-18

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!