Beosound 3000 Type 2671-2680 .pdf - abo - center

More documents

Recommendations

Info

5.12 Repair tips, English Mounting of wire for glass doors - Turn the wire pulley G clockwise until it stops. (Closed door position). - Turn the wheel H in click position. - Mount the wire in the wire pulley H (the end with the heavy spring). - Run the wire in the second innermost groove of the wire pulley H (underneath the pulley), up around the uppermost pulleys (I, J, K and L) and down around the lowermost pulleys (M, N, and O). - Turn the pulley G anticlockwise. - Fasten the wire in the pulley H. - Mount the wire on pulley P and turn pulley G to check that everything is OK. ABO-CENTER v/HENRIKSENS ELEKTRONIK Readjustment of wire - Turn the pulley G such that the centre of the pulleys G and H is flush with the upper edge of the tower X. - Push the wire clamping clip towards the centre and tighten (not too tight). L K I J H X G M P O N
Repair tips, English 5.13 Adjustment of the glass doors - Open the glass doors, press • and wait for the glass doors to close and disconnect main voltage. - Remove the seven screws A in the back cover. Pull out the back cover by wrenching the corners C of the back cover to the side. - Remove the five screws B, and lift PCB12/15 out of the cabinet. - Loosen the top and bottom screws holding the maladjusted glass door on the wire (only one door at the time). - The maladjusted glass door can now be pushed to the middle-stop and the screws at the top and at the bottom of the glass door have to be tighten firmly. - Connect the main voltage. Open the glass doors, press • and wait for the glass doors to close and disconnect main voltage. - If necessary adjust the other glass door in the same way. Note, be careful not to loosen both glass doors at the same time. ABO-CENTER v/HENRIKSENS ELEKTRONIK
Page 1 and 2:
BeoSound 3000 Type 2671, 2672, 2673
Page 3 and 4:
1.2 Specification guidelines SPECIF
Page 5 and 6:
1.4 Wiring of transformer Wiring of
Page 7 and 8:
1.6 Brief operation guide Brief ope
Page 9 and 10: 2.1 Explanation of diagram Explanat
Page 11 and 12: Wiring diagram Wiring diagram 2.4 2
Page 13 and 14: AM block diagram Block diagram 2.6
Page 15 and 16: ABO-CENTER v/HENRIKSENS ELEKTRONIK
Page 33 and 34: List of electrical parts 3.1 List o
Page 35 and 36: List of electrical parts 3.3 P76 72
Page 37 and 38: List of electrical parts 3.5 PCB14,
Page 39 and 40: List of electrical parts 3.7 C2 401
Page 41 and 42: List of electrical parts 3.9 3.9 Li
Page 45 and 46: List of mechanical parts 4.4 4.4 Li
Page 47 and 48: List of mechanical parts 4.6 Center
Page 49 and 50: Testmodes, English 5.1 TM (test mod
Page 51 and 52: Testmodes, English 5.3 TM07 Tuner v
Page 53 and 54: Testmodes, English 5.5 TM27 Service
Page 55 and 56: Testmodes, English 5.7 E7: Last err
Page 57 and 58: Testmodes, English 5.9 To use CD te
Page 59: Repair tips, English 5.11 Removal o
Page 63 and 64: Service- and pin code, English 5.15
Page 65 and 66: Service- and pin code, English 5.17
Page 67 and 68: Dismantling, English 6.1 Dismantlin
show all

Beosound 3000 Type 2671-2680 .pdf - abo - center

Create successful ePaper yourself

Delete template?

Save as template?