JORDAHL Channels and Accessories - Pretec

Channel Overview
JORDAHL ® offers following channels with corresponding
bolts:
JTA-W
Traditionally JORDAHL ® profiles are hot rolled
from a billet. Therefore they are particularly free
of residual stresses. The geometry is optimized,
well-suited for dynamic loads and high clamping
forces from the T-bolts. Anchor channels made
from hot rolled profiles are the preferred solution
for curtain walls under high wind loads, elevators,
heavy pipes under pre-stressed post-tensioned
bridges, etc.
JXA
The toothed, hot-rolled JXA profiles absorb
longitudinal forces due to toothing between
the channel lip and bolt.
JGB
Anchor channels with W and K profiles are used
to fasten railings with special anchors in narrow
members.
JTA-K
Cold-formed JORDAHL ® profiles JTA-K are characterized
by their consistent dimensions over the
complete cross-section surface. They can be used,
for example, to connect prefabricated elements
that absorb the dead weight of facades.
JZA
Cold-formed tooth profiles JZA absorb loads in the
longitudinal direction of the channel.
JM
Deutsche Kahneisen Gesellschaft mbH supplies
mounting channels as W and K profiles in toothed
form as well as non-toothed form.
Perforated, unperforated and in many types of
cross-section, they offer great versatility in use.
JTB
Profiled metal sheet connector channels facilitate
efficient connection of profiled metal sheets ( wall
and roof ) using self-drilling screws.
Steel Grades
Most profiles are made from carbon steel material
conforming to EN 10025 with a minimum yield
strength of 235 N/mm 2 . Stainless steel grade A4
conforming to EN 10088 is available upon request.
Round Anchors
Unless custom design is required, anchors are
generally cold-headed in a fully automated and
monitored production process.
Channels and Accessories
5