3DH-47EXTRA-Manual - 3D Hobby Shop

More documents

Recommendations

Info

6 Remove the covering over the horizontal stabilizer opening and servo opening on both sides of the fuselage as shown. Trim rear section of stabilizer opening to ensure good clearance for elevator joiner.
7 Insert horizontal stabilizer (note the color scheme on top). Use a ruler to square the stabilizer side to side as shown. Insert carbon wing tube into fuselage. Measure from tube to horizontal stabilizer on both sides of fuselage. Equalize measurements to square the stabilizer.
Page 1 and 2: 1 3 D H O B B Y S H O P . C O M Ass
Page 3 and 4: 3 Attach landing gear to fuselage u
Page 5: 5 Remove one square of covering fro
Page 9 and 10: 9 Install elevator half with joiner
Page 11 and 12: 11 Use small drill bit, small screw
Page 13 and 14: 13 Pushrod connectors - The pushrod
Page 15 and 16: 15 Install your receiver onto the r
Page 17 and 18: 17 Remove covering over servo openi
Page 19 and 20: 19 Balancing: The recommended start

3DH-47EXTRA-Manual - 3D Hobby Shop

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?