Prismatik UniPack Technique Manual - Glidewell Dental Labs

More documents

Recommendations

Info

Apply a thin layer of porcelain separator prior to the second application of margin material. Add a second layer of margin material to open areas. Do not over build. Remove excess moisture with a tissue. Brush away any loose particles. Remove from the die and fire. 27
Margin Firing Parameters Low Temp. 482ºC 900°F Vac. Level Full High Temp. 960ºC 1760ºF Pre-Dry Time 4 min. Vac. Start 538ºC 1000ºF Hold Time 1 min. Heat Rate 39ºC/min. 70ºF/min. Vac. Release 959ºC 1758ºF Cool Time 1 min. Check for open or insufficient margins. Add and re-fire if necessary. Opaceous Dentin <strong>Technique</strong> In cases where insufficient tooth structure results in increased and unwanted translucency, <strong>Prismatik</strong> Opaceous Dentin is used to build-out the dentin-form of the restoration. 28
Page 1 and 2: Dental Technology Reference Guide C
Page 3 and 4: TABLE OF CONTENTS Chapter 1 - Benef
Page 5 and 6: Normal staining and glazing procedu
Page 7 and 8: ecause it doesn’t reduce porosity
Page 9 and 10: Figure 3 - Prismatik UniPack Shade
Page 11 and 12: Opaceous Dentin Powders In cases wh
Page 13 and 14: Chapter 3 - UniPack Techniques Post
Page 15 and 16: 2nd Opaque Firing Parameters Low Te
Page 17 and 18: Keep internal aspect of crown clean
Page 19 and 20: Always use the shade tab to check y
Page 21 and 22: 1st Opaque Firing Parameters Low Te
Page 23 and 24: Anterior Build-up Technique Proceed
Page 25 and 26: Anterior Stain and Glaze Techniques
Page 27 and 28: The finished UniPack restoration af
Page 29: The margin material should not be o
Page 33 and 34: Prismatik Ceramic Kits Starter Kit
Page 35 and 36: PROBLEM KNOWN CAUSES SOLUTIONS Bubb
Page 37: PROBLEM KNOWN CAUSES SOLUTIONS Crac

Prismatik UniPack Technique Manual - Glidewell Dental Labs

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?