Prismatik UniPack Technique Manual - Glidewell Dental Labs

More documents

Recommendations

Info

Figure 2 – Prismatik UniPack Firing Parameters 1st Opaque 2nd Opaque Margin 1st Bake 2nd Bake Glaze Add-On Low Temp. 538°C 1000°F 538°C 1000°F 482°C 900°F 380°C 716°F 380°C 716°F 482°C 900°F 482°C 900°F Pre-Dry Time 6 min. 6 min. 4 min. 6 min. 6 min. 6 min. 6 min. Heat Rate 55°C/min. 100°F/min. 55°C/min. 100°F/min. 39°C/min. 70°F/min. 55°C/min. 100°F/min. 55°C/min. 100°F/min. 55°C/min. 100°F/min. 55°C/min. 100°F/min. Vac. Level Full Full Full Full Full Full Full Vac. Start 538°C 1000°F 538°C 1000°F 538°C 1000°F 570°C 1058°F 570°C 1058°F N/A 538°C 1000°F Vac. Release 1070°C 1958°F 965°C 1769°F 959°C 1758°F 870°C 1598°F 865°C 1589°F N/A 774°C 1425°F High Temp. 1070°C 1958°F 1020°C 1868°F 960°C 1760°F 870°C 1598°F 865°C 1589°F 860°C 1580°F 815°C 1499°F Hold Time 0 0 1 min. 0 0 0 0 Cool Time 3 min. 3 min. 1 min. 1 min. 1 min. 1 min. 1 min.
Figure 3 – Prismatik UniPack Shade Indicator
Page 1 and 2: Dental Technology Reference Guide C
Page 3 and 4: TABLE OF CONTENTS Chapter 1 - Benef
Page 5 and 6: Normal staining and glazing procedu
Page 7: ecause it doesn’t reduce porosity
Page 11 and 12: Opaceous Dentin Powders In cases wh
Page 13 and 14: Chapter 3 - UniPack Techniques Post
Page 15 and 16: 2nd Opaque Firing Parameters Low Te
Page 17 and 18: Keep internal aspect of crown clean
Page 19 and 20: Always use the shade tab to check y
Page 21 and 22: 1st Opaque Firing Parameters Low Te
Page 23 and 24: Anterior Build-up Technique Proceed
Page 25 and 26: Anterior Stain and Glaze Techniques
Page 27 and 28: The finished UniPack restoration af
Page 29 and 30: The margin material should not be o
Page 31 and 32: Margin Firing Parameters Low Temp.
Page 33 and 34: Prismatik Ceramic Kits Starter Kit
Page 35 and 36: PROBLEM KNOWN CAUSES SOLUTIONS Bubb
Page 37: PROBLEM KNOWN CAUSES SOLUTIONS Crac

Prismatik UniPack Technique Manual - Glidewell Dental Labs

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?