HESC-UPS Manual - Tri-M Systems Inc.
HESC-UPS Manual - Tri-M Systems Inc.
HESC-UPS Manual - Tri-M Systems Inc.
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
18/09/2003 <strong>HESC</strong>-<strong>UPS</strong> <strong>Manual</strong><br />
Output: unsigned int – value from ADC converter<br />
Units: ADC converter value<br />
Range: data range is 0 to 65,535Description:<br />
Returns the main input voltage (mV).<br />
16. MainVCmd() (0x91)<br />
Purpose:<br />
The MainVCmd() function provides the Host power management system with an accurate main input voltage. The<br />
Host management system can use this voltage, along with main input current information to help enable intelligent,<br />
adaptive power management systems.<br />
Protocol: Read Word<br />
Output: unsigned int – main input voltage in mV<br />
Units: mV<br />
Range: 0 to 65,535<br />
17. MainICmd() (0x92)<br />
Description:<br />
Returns the current being supplied to the <strong>HESC</strong> (mA).<br />
Purpose:<br />
The MainICmd() function provides the Host power management system an accurate measure of the current flowing<br />
into the <strong>HESC</strong>. The current being report by the MainICmd() will be either from the main input or battery or some from<br />
both inputs if both the main input and battery are the same potential. Compare the voltages returned by BattIVCmd()<br />
and the MainVCmd() to determine the source of the power.<br />
Protocol: Read Word<br />
Output: unsigned int – input current rate in mA increments<br />
Units: mA<br />
Range: 0 to 65,535<br />
18. InputPwrCmd() (0x93)<br />
Description:<br />
Returns the power being supplied to the <strong>HESC</strong>.<br />
Purpose:<br />
The InputPwrCmd() function provides the Host power management system a measure of the power flowing into the<br />
<strong>HESC</strong>-SER. The power being report by the InputPwrCmd() will be either from the main input or battery or some from<br />
both inputs if both the main input and battery are the same potential. Compare the voltages returned by BattIVCmd()<br />
and the MainVCmd() to determine the source of the power.<br />
Protocol: Read Word<br />
Output: unsigned int – input power in 10mW increments<br />
Units: 10mW<br />
Range: 0 to 65,535<br />
19. BattPwrCmd() (0x94)<br />
Description:<br />
Returns the power being charged/discharge to the battery through the <strong>HESC</strong>.<br />
<strong>Tri</strong>-M Engineering Tel: 800.665.5600, 604.945.9565<br />
1407 Kebet Way, Unit 100 Fax: 604.945.95<br />
Port Coquitlam, BC, V3C 6L3 E-mail: info@tri-m.com<br />
Canada<br />
Web site: www.tri-m.com<br />
18
Change language