Owners manual 2005.qxp - MR Hifi

IMPORTANT READING
before use...
Receiving your new Densen product
Every Densen product is the result of a meticulous process, in
which everything is produced and checked with the utmost
care.
When you receive your Densen, the first thing you should do is
to check it for physical damage sustained during transport. Is
the shipping carton in perfect order? Is the unit? If not, you
should contact you dealer immediately,and ask for the name
of the carrier, so that a written claim to cover shipping damage
can be initiated.
The right to any claim against a public carrier can be forfeited
if the carrier is not notified promptly and if the shipping
carton and packaging material are not available for inspection.
Save all packing material until the claim has been settled.
Important Guidelines
Read all the instructions before connecting or operating the
component. Keep this manual so you can refer to these safety
instructions. Heed all warnings and safety information in
these instructions. Follow all operating instructions.
When unpacking your new Densen equipment make sure
that none of the tape used for packing touches the cabinet
as it will be very difficult to remove again and may damage
the cabinet.
Save the Densen shipping carton and all enclosed packing
material for future use. Shipping or moving your Densen in
anything other than the original packing material may result
in severe damage to your product.
Always use the supplied white cotton gloves to handle the
product to prevent fingerprints and grease. The gloves will
also protect your hands from sharp edges.
Your Densen should be placed on a dry fixed surface. So as
not to impede cooling, never place anything on top of
Densen integrated amplifiers or Densen power amplifiers; there
should be a minimum of 30 centimetres free space above
and 5 centimetres on each side of the amplifier.
Do not expose the amplifier to excessive heat, cold, sunlight,
moisture or dust. The Densen amplifiers in particular can reach
rather high temperatures. As a rule of thumb; if you can
place your hand on top of the cabinet for longer than two
seconds your amplifier is not overheated.
Only connect and disconnect cables when your Densen is
switched off, and the power supply is removed. Otherwise you
will risk damages not covered by the warranty.
Incidentally, the various wiring possibilities for the various products
are indicated in the product descriptions that will follow
later in this owners manual.
The unit must only be connected to a power supply of the
type and voltage specified on the rear panel of the unit.
Connect the component to the power outlet only with the
supplied power supply cable or an exact equivalent. Do not
modify the supplied cable in any way. Do not attempt to
4