Husqvarna - AR19 - JW Hire & Sales Ltd

More documents

Recommendations

Info

Starting the engine Check that all daily maintenance as described in the maintenance schedule has been performed. Check that there is sufficient fuel in the tank. RUNNING Fuel valve Open the fuel valve. Turn the lever all the way to the right. 8011-072 Choke control When starting the engine warm, the lever should be in the right position; see the illustration. When starting the engine cold or partially warm, turn the lever completely or partly to the left. Move the lever back to the right once the engine starts. When the engine is cold, it may be best to move the lever back in several stages. Find the position where the engine runs smoothly. 8011-035 Engine switch Turn the engine switch clockwise to ON. OFF ON 8011-071 Starter handle Misuse of the starter handle can damage the starter. Never twist the starter cord around your hand. Pull out the handle slowly until the gears mesh. Then give a sharp pull on the starter handle. Do not pull out the starter cord completely and do not let go of the starter handle when extended. 8011-044 20 – English
RUNNING Throttle Adjust the engine speed with the throttle. Moving the lever to the left increases throttle and to the right decreases throttle. For machines with a throttle on the handle, the throttle on the engine should be set at idle position. 8011-034 Cutting the engine If the engine has been running full out, let it run easily for about 30 seconds to 1 minute at low speed. Engine switch Turn the engine switch counterclockwise to OFF. ON OFF 8011-026 Fuel valve Close the fuel valve. Turn the lever all the way to the left (see illustration). 8011-036 English – 21
Page 1: Operator´s manual AR19 AR25 Please
Page 4 and 5: Congratulations INTRODUCTION Thank
Page 6 and 7: SYMBOLS AND DECALS WARNING! Xxxx xx
Page 8 and 9: SAFETY INSTRUCTIONS General The obj
Page 10 and 11: SAFETY INSTRUCTIONS Preparations
Page 12 and 13: SAFETY INSTRUCTIONS • Smoking, op
Page 14 and 15: SAFETY INSTRUCTIONS Maintenance •
Page 16 and 17: PRESENTATION Engine Exterior engine
Page 18 and 19: PRESENTATION Spark plug The engine
Page 20 and 21: Controls on the handle Rear wheel c
Page 24 and 25: RUNNING Aeration tips Should I wate
Page 26 and 27: MAINTENANCE Maintenance schedule Th
Page 28 and 29: MAINTENANCE Cleaning the sludge res
Page 30 and 31: MAINTENANCE Ignition system The eng
Page 32 and 33: Replacing and adjusting the drive b
Page 34 and 35: MAINTENANCE Wheels Replacing the dr
Page 36 and 37: MAINTENANCE Tines and tine shaft Re
Page 38 and 39: MAINTENANCE Chain Replacing the cha
Page 40 and 41: LUBRICATION Lubrication schedule 80
Page 42 and 43: LUBRICATION Checking the engine’s
Page 44 and 45: 7. Adjustment for rear wheel depth/
Page 46 and 47: ASSEMBLY INSTRUCTIONS Applies to mo
Page 48 and 49: WIRING DIAGRAM 8011-099 8011-050 1.
Page 50 and 51: TECHNICAL DATA Engine unit AR19 AR2
Page 52 and 53: ○ ○ ○ ○ ○ ○ ○ ○ ○
Page 54 and 55: ○ ○ ○ ○ ○ ○ ○ ○ ○
Page 56: ´+H"r6=¨ 114 00 28-26 2001W35

Husqvarna - AR19 - JW Hire & Sales Ltd

Create successful ePaper yourself

Delete template?

Save as template?