Cubix User Manual Rev. 01a - CHAUVET® Lighting
Cubix User Manual Rev. 01a - CHAUVET® Lighting
Cubix User Manual Rev. 01a - CHAUVET® Lighting
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
3. SETUP<br />
AC Power<br />
Power Linking<br />
This product has an auto-ranging power supply and it can work with an input voltage<br />
range of 100~240 VAC, 50/60 Hz.<br />
To determine the power requirements for a particular fixture, see the label affixed to<br />
the back plate of the fixture or refer to the fixture’s specifications chart. A fixture’s<br />
listed current rating indicates its average current draw under normal conditions.<br />
Always connect this product to a protected circuit (circuit breaker or fuse),<br />
making sure that it has an appropriate electrical ground to avoid the risk of<br />
electrocution or fire.<br />
Never connect this product to a rheostat (variable resistor) or dimmer circuit,<br />
even if the rheostat or dimmer channel serves only as a 0 to 100% switch.<br />
This fixture provides power linking via the Edison/IEC outlet located in the back of the<br />
unit. Please see the diagram below for further explanation.<br />
Generic Fixture Housing<br />
Power Linking<br />
Diagram<br />
1 st Fixture 2 nd Fixture 3 rd Fixture<br />
Other fixtures<br />
You can power link up to 26 <strong>Cubix</strong> units on 120 VAC or up to 45 <strong>Cubix</strong> units<br />
on 230 VAC.<br />
The power linking diagram shown above corresponds to the North American<br />
version of this product ONLY! If using this product in other markets, you must<br />
consult with the local <strong>CHAUVET®</strong> distributor as power linking connectors and<br />
requirements may differ in your country or region.<br />
Page 6 of 18 <strong>Cubix</strong> <strong>User</strong> <strong>Manual</strong> (<strong>Rev</strong>. <strong>01a</strong>)
Change language