Wheel balancer machine for trucks, bus and car wheels with manual ...

0123
PRESETTINGS MEMORIZED ALSO WITH INOPERATIVE MACHINE:
+
+
F ↑ a ↓ a
- UNIT of measurement of unbalance grams/ounces
PRESETTINGS LOST WHEN MACHINE IS SWITCHED OFF:
F
F
+
or
+
↑ b
↓ b
- UNIT OF MEASUREMENT OF WIDTH mm/inch
(from "PRESETTING OF DIMENSIONS"
by selecting WIDTH)
N.B.: in inches each time the machine is switched on.
F
+
or
↑ d
- UNIT OF MEASUREMENT OF DIAMETER mm/inch
(from "PRESETTING OF DIMENSIONS"
by selecting DIAMETER).
N.B.: In inches each time the machine is switched on.
F
+
↓ d
DISPLAY OF UNBALANCE:
F
ALU
Dynamic Static Dynamic
ALU1 ALU2 ALUS ALU1
8.2 - PRESETTING WITH GAUGE EXTENSION
The extension increases the distance measuring range of the gauge by 10 cm (fig. 5A).
Proceed as follows:
- Insert the extension on the distance gauge.
- Measure the distance as already described in the above procedures.
- After reading value “a” on the scale, return the gauge to 0 and preset the value “a + 10” in manual
mode.
- Preset the diameter and width in manual mode as already illustrated.