Wheel balancer machine for trucks, bus and car wheels with manual ...

0123
SPECIAL MAINTENANCE
(Only for specialized personnel)
14 - TO CHANGE SUPPLY VOLTAGE
- Always check the required voltage on the machine nameplate.
- Standard power supply 220 - 240 V / 50 Hz single phase.
- For 115 V power supply, the components must be replaced as indicated in the attached exploded
drawing.
15 - SELECTING OF MACHINE PARAMETERS
To preset the machine parameters (DF; I; S), press push-buttons and as in
self-calibration. When the position LEDs stop flashing, instead of performing the spin, press the following
push-buttons within 5 seconds and in the correct sequence:
[ ↓ a ] then [ ↑ a ] then [ F ]
After pressing [ ↓ a ] and [ ↑ a ], the displays go out. After pressing [ F ], the current value of " DF " appears;
it can be modified with [ ↑ b ] and [ ↓ b].
Press [ ↑ a ] to modify parameter " I ". The current value (in %) appears on the right display, while the
wording "in" and the symbol " ⎯ " appear on the left display if the correction is negative or else " " if it
is positive. Modify with [ ↑ b ] and [ ↓ b ]. Press [ ↑ a ], the value of parameter " S " appears on the right
display; modify with [ ↑ b ] and [↓ b]. To finish, press [ ↑ a ].
N.B.: when [ FINE ] is pressed during any one of the parameter presetting phases, the system interrupts
such function and sets the parameters with basic values.
After modifying such values, the machine requires self-calibration again.
CAUTION! The basic configuration values: " DF "= 120
" I " = +0
" S " = 330
The values at which the machine is factory set are given on a special nameplate inside the machine.
F
C