BA Mediasat ID Sat URC 3000 v3, 105x210 mm CS4.indd - Ruwido
BA Mediasat ID Sat URC 3000 v3, 105x210 mm CS4.indd - Ruwido
BA Mediasat ID Sat URC 3000 v3, 105x210 mm CS4.indd - Ruwido
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
GB<br />
E. Identifying the 3 digit code<br />
To identify the currently progra<strong>mm</strong>ed 3 digit code, please follow the steps below.<br />
1. Press the TV key and keep it pressed until the green LED fl ashes twice in quick<br />
succession. (after approx. 3 seconds).<br />
2. Within 10 seconds of seeing the 2 fl ashes above, enter the code 0 0 2, the green<br />
LED fl ashes twice again.<br />
3. To identify the currently saved code, press the number key “1” for the fi rst digit,<br />
“2” for the second digit and “3” for the third digit. After each digit key has been<br />
pressed, count the number of times the LED fl ashes.<br />
Please note:<br />
If the LED does not fl ash after you have pressed one of the above selection keys, the<br />
respective code digit is 0.<br />
Example:<br />
• Press key “1” for hundreds. The LED fl ashes three times. The fi rst digit of your<br />
3-digit code is thus 3.<br />
• Press key “2” for tens. The LED fl ashes once. The second digit of your 3-digit code<br />
is thus 1.<br />
• Press key “3” for units. The LED fl ashes six times. The third digit of your 3-digit<br />
code is thus 6.<br />
In this example, the code is thus 316.<br />
We reco<strong>mm</strong>end that you write down the codes for your devices in the respective fi eld<br />
in this manual so that they are available in case you need to re-program your <strong>ID</strong> SAT<br />
remote control. The progra<strong>mm</strong>ed codes retain in the memory even in case of a battery<br />
change.<br />
To identify the code for the DTT and SAT mode please proceed as described above for<br />
television sets, but instead of “TV” key use the “DTT” or “SAT” key.<br />
Write down the 3-digit codes here:<br />
DTT<br />
SAT<br />
TV<br />
F. Reset<br />
USER MANUAL<br />
<strong>ID</strong> SAT universal remote control 3 in 1<br />
This functionality resets all settings to the factory settings.<br />
Press a Mode key (DTT, SAT or TV) and keep it pressed until the LED fl ashes twice<br />
in quick succession (after approx. 3 seconds). After that enter the code 0 0 0, the LED<br />
fl ashes twice again. After this procedure, the <strong>ID</strong> SAT remote control is reset to the<br />
factory settings.<br />
20<br />
<strong>BA</strong> <strong>Mediasat</strong> <strong>ID</strong> <strong>Sat</strong> <strong>URC</strong> <strong>3000</strong> <strong>v3</strong>, <strong>105x210</strong> <strong>mm</strong> <strong>CS4.indd</strong> 20 19.05.2010 17:52:09