Diagram 2 - TwinHeat

More documents

Recommendations

Info

$F:\dokumenter\Produkt\Salg\Målskitse\Combi MCS.dwg ... - TwinHeat$

$(F:\\dokumenter\\Thomas\\M\345lskitse\\Engelsk ... - TwinHeat$

10 <strong>Diagram</strong> 3 – Connection to the chimney * Prefabricated module chimneys should not be placed on top of the flue outlet, as this allows rainwater or possible condense water to run directly down into the heat exchanger of the boiler, where it will cause corrosion ! Brick-build or block-build chimney Brick-build or block-build chimney Insulation Elbow with clean out hole Draft stabilizer mounted in chimney Clean out Draft stabilizer mounted on flue pipe Clean out *Module chimney with steel or ceramic liners Insulated tee module with draft stabilizer Insulated tee module with clean out Wall support *Module chimney with steel or ceramic liners Insulation Insulated tee module with clean out Elbow with clean out hole Draft stabilizer mounted on flue pipe Wall support DIAGRAM 3
11 <strong>Diagram</strong> 4 – Connection of the external auger Fuel from silo placed at the loft above Flexible hose Fuel valve Automatic fire damper closes incase of fire in the boiler room Fuel from external silo Flexible hose Fuel valve The auger must not support on the stoker unit and vibrations from the auger must not be transmitted to the stoker unit. DIAGRAM 4
Page 1 and 2: MANUAL FOR INSTALLATION ME20i ME40
Page 3 and 4: 3 The sketch indicates the recommen
Page 5 and 6: 5 Connection of the safety heat exc
Page 7 and 8: 7 Diagram 1 - How to fit the water
Page 9: 9 Diagram 2 - Connection to the hea
Page 13 and 14: 13 Diagram 5.1 - Electrical diagram

Diagram 2 - TwinHeat

Create successful ePaper yourself

Delete template?

Save as template?