DH6/10

Specifications
Nominal dimension
Maximum working pressure (port A) MPa (kgf/cm 2 )
Maximum flow rate L/min
Minimum controlled flow rate cm 3 /min (Note 1)
Temperature compensation (-20 to +70)
Accuracy of flow regulation
(with respect to
maximum flow rate)
Pressure compensation
Nominal dimension 5 has pressure
difference of 20.6 MPa 210 kgf/cm 2
Nominal dimension 10 and 16 have pressure
difference of 30.9 MPa315 kgf/cm 2
Maximum operating pressure difference MPa (kgf/cm 2 ) (Note 2)
Mass kg
(Note 1) The minimum controlled flow rate shows the maximum leak amount from port A to port B when the adjusted opening is 0.
(port A: Maximum working pressure, port B: 0 Mpa)
(Note 2) This shows the minimum pressure difference between the inlet and outlet necessary for regulating the flow rate. However,
if the valve is used with the maximum controlled flow rate, the pressure drop amount inside the valve is added and the
pressure difference between the inlet and outlet is approximately 1.0 MPa.
Sub-plate
Valve type Sub-plate type Connection diameter Mass
When you use a
sub-plate, please
place an order for
the left sub-plate
type.
For the
dimension
drawing, refer to
pages 4 and 8 of
the appendix.
Accessories
Mounting bolt
Type Hexagon socket head cap thread Quantity Tightening torque Nm (kgfcm)
Opening - Flow rate characteristics (viscosity 36 mm 2 /s (cSt))
Flow rate (L/min)
FJC5 FJC10 FJC16
Opening scale
Maximum controlled flow rate symbol
Flow rate (L/min)
Opening scale
Maximum controlled flow rate symbol
Flow rate (L/min)
Opening scale
Maximum controlled flow rate symbol
Temperature and pressure compensated flow regulating valve (1)
Pressure drop characteristics (viscosity 36 mm 2 /s (cSt))
In the case of check valve free flow
Pressure drop amount (MPa)
FJC5 FJC10 FJC16
Pressure drop amount (MPa)
Pressure drop amount (MPa)
Flow rate (L/min)
Flow rate (L/min)
Flow rate (L/min)
3-23