DH6/10

Solenoid controlled pilot operated directional valve (1)
DEH22 (2 position valve)
Integrated terminal box type
Conduit tube connection port
In the case of oil immersion type DC solenoid
Machining dimension of manifold
2-6.5 Drilled depth 8
4-24.5 (for port P, A, B, T)
(Note) Port L is not used.
2-10 (for port X, Y)
6-M12 screw depth 22
O-ring
(for port X, Y, L)
(Locating pin)
280.4 (Hydraulic offset type)
308.5 (Spring offset type)
In the case of oil immersion type AC solenoid
*
O-ring
(for port A, B, P, T)
The dimension marked with * differs depending
on the type.
With choke valve (S1, S2): +55 mm
With pressure reducing valve (R): +50 mm
Dimension
Port P
Port A, B
Port T
DEH22 (3 position valve)
Integrated terminal box type
Conduit tube connection port
Machining dimension of manifold
2-6.5 Drilled depth 8
4-24.5 (for port P, A, B, T)
In the case of oil immersion type DC solenoid
3-10 (for port X, Y, L)
6-M12 screw depth 22
In the case of oil immersion type AC solenoid
(Note) Port L is not used in the case
of the spring center type.
Use port L with tank pressure in the case
of the hydraulic center type.
*
The dimension marked with * differs depending
on the type.
With choke valve (S1, S2): +55 mm
With pressure reducing valve (R): +50 mm
O-ring
(for port X, Y, L)
(Locating pin)
280.4 (Spring center type)
305.7 (Hydraulic center type)
O-ring
(for port A, B, P, T)
Dimension
Port P
Port A, B
Port T
1-28