Download complete user manual (PDF). - Brocade

RSTP support for PB and PBB 13
Set the admin-pt2pt-mac to enabled or disabled. If set to enabled, then a port is connected to
another port through a point-to-point link. The point-to-point link increases the speed of
convergence. This parameter, however, does not auto-detect whether or not the link is a physical
point-to-point link.
The force-migration-check parameter forces the specified port to sent one RST BPDU. If only STP
BPDUs are received in response to the sent RST BPDU, then the port will go return to sending STP
BPDUs.
Show commands
The show rstp command output displays VPLS instance ID if RSTP is running in VPLS VLAN.
Brocade(config)# show rstp
Syntax: show rstp [vlan vlan-id] [vpls id vpls-id]
Brocade(config)# show rstp
VPLS Instance ID 1 - RSTP instance 0
--------------------------------------------------------------------
RSTP (IEEE 802.1w) Bridge Parameters:
Bridge Bridge Bridge Bridge Force tx
Identifier MaxAge Hello FwdDly Version Hold
hex sec sec sec cnt
0001000480a04000 20 2 15 Default 3
RootBridge RootPath DesignatedBridge Root Max Hel Fwd
Identifier Cost Identifier Port Age lo Dly
hex hex sec sec sec
0001000480a04000 0 0001000480a04000 Root 20 2 15
RSTP (IEEE 802.1w) Port Parameters:
|
Port Pri PortPath P2P Edge Role State Designa- Designated
Num Cost Mac Port tedcost bridge
1/3 128 20000 T F DISABLED DISABLED 0 0000000000000000
1/13 128 20000 T F DISABLED DISABLED 0 0000000000000000
The show rstp detail command displays VPLS instance ID if RSTP is running in VPLS VLAN.
Brocade(config)# show rstp detail vpls id 1
Syntax: show rstp detail [vlan vlan-id] [vpls id vpls-id]
NetIron(config)#show rstp detail
VPLS Instance ID - 1 - RSTP instance 0
--------------------------------------------------------------------
RSTP (IEEE 802.1w) Bridge Parameters:
BridgeId 0001000480a04000, RootBridgeId 0001000480a04000
Control ports - ethernet 1/3 ethernet 1/13
ForceVersion 2, MigrateTime 3, TxHoldCount 3
RSTP (IEEE 802.1w) Port Parameters:
Port 1/3 - Role: DISABLED - State: DISABLED
Port 1/13 - Role: DISABLED - State: DISABLED
The show mpls vpls detail command displays the VPLS instance ID if RSTP is running in VPLS VLAN.
Multi-Service IronWare Switching Configuration Guide 435
53-1002820-02