Stag PP39 Users Manual - Matthieu Benoit

More documents

Recommendations

Info

39M 100 EPROM & EEPROM MODULE SPECIFICATIONS FUSES POWER CONNECTION SERIAL RS232C INTERFACE PORT CONNECTOR MAINS POWER ON/OFF SWITCH 1.1-02
1.2 MODULES A variety of modules is available to plug into the main frame. This guarantees future flexibility to support new devices as they are developed. 39M100 – EPROM/EEPROM This module supports NMOS and CMOS, EPROM and EEPROM devices in both 24 and 28 pin DIPs packages. The module features algorithms for fast programming and it supports Silicon Signature* technology for automatic device identification. Sockets are provided for set programming of two devices simultaneously or they can be used as a mini-ganger. The <strong>PP39</strong> can be configured as an 8, 16 or 32 bit machine. Access time tests can be performed and an auto-recall feature is incorporated where pre-set parameters can be recalled from a non-volatile memory at any time for ease of use. 39M200 MICROPROCESSOR MODULE This module will program single chip microprocessors containing EPROM from AMD, Intel, NEC and Motorola in both 40 pin and 28 pin DIPs packages. (Revision 2) 1.2-01
Page 1: Operating Manual for RS PP39 Univer
Page 4 and 5: 39M200 Section 7 39M200 INTRODUCTIO
Page 7: SECTION 1
Page 11: 1.1 INTRODUCTION The PP39 is a Univ
Page 15 and 16: 1.3 THE KEYBOARD For data entry and
Page 17 and 18: 1.4 INITIAL SETTING UP PROCEDURE Be
Page 19 and 20: 1.5 SELECTION OF ‘LOCAL’ OR ‘
Page 21: SECTION 2
Page 25 and 26: (Revision 2) 2.1-01
Page 27 and 28: 2.2 RAM OPERATING STRUCTURE (Revisi
Page 29 and 30: 2.3 LIST OF ‘SET’ COMMANDS set
Page 31 and 32: LIST OF ‘SET’ COMMANDS (continu
Page 33: SECTION 3
Page 36 and 37: Scanning device types and manufactu
Page 38 and 39: LIST OF DEVICES AND DEVICE CODES (c
Page 44 and 45: Mode (ii): Single Key Operation Pre
Page 47 and 48: BIT MODES 4.1 SELECTION OF BIT MODE
Page 49 and 50: 4.2 8-BIT MODE In the 8-Bit mode, t
Page 51 and 52: DISPLAY 8-Bit Mode By pressing Key
Page 53 and 54: 4.3 GANG MODE LOAD: Two devices wit
Page 55 and 56: 4.4 16-BIT MODE LOAD: The two EPROM
Page 57 and 58: DISPLAY The two bytes can be displa
Page 59 and 60: 4.5 32-BIT MODE The machine can be
Page 61 and 62: DISPLAY The four Bytes can be displ
Page 63:
SECTION 5
Page 66 and 67:
5.1-02
Page 68 and 69:
5.2-02
Page 70 and 71:
5.3-02
Page 72 and 73:
Should the PROGRAMMING fail, by pre
Page 74 and 75:
5.5-02
Page 76 and 77:
5.6-02
Page 78 and 79:
5.7-02
Page 80 and 81:
SETTING UP THE RAM AND THE DEVICE A
Page 82 and 83:
32-BIT MODE: ADDITIONAL PARAMETERS
Page 84 and 85:
5.9-02
Page 87 and 88:
RAM FUNCTIONS 6.1 INTERLACE* Interl
Page 89 and 90:
6.2 LIST AND EDIT The data field di
Page 91 and 92:
6.3 INSERT Insert is part of the ed
Page 93 and 94:
6.4 DELETE Delete is also part of t
Page 95 and 96:
6.5 BLOCK MODE (SET F4) SETTING ADD
Page 97 and 98:
(Revision 2) 6.5-03
Page 99 and 100:
6.6 FILLING THE RAM By pressing SET
Page 101 and 102:
*A larger number of up to 8 digits
Page 103 and 104:
6.7 STRING SEARCH This function all
Page 105 and 106:
For instance: 47 STAG< Cursor The s
Page 107:
SECTION 7
Page 111 and 112:
(Revision 2) 7.1-01
Page 113 and 114:
(Revision 2) 7.2-01
Page 115 and 116:
7.3 LIST OF ‘SET’ COMMANDS set
Page 117:
SECTION 8
Page 120 and 121:
Scanning device types and manufactu
Page 122 and 123:
8.2-02
Page 125 and 126:
DEVICE FUNCTIONS 9.1 LOAD Loading t
Page 127 and 128:
9.2 PROGRAMMING SEQUENCE Empty Test
Page 129 and 130:
9.3 PROGRAMMING Once the device has
Page 131 and 132:
9.3.1 Verify Verify Pass-Security B
Page 133 and 134:
9.4 CHECKSUM To do a checksum Press
Page 135 and 136:
9.5 DEVICE/RAM ADDRESS LIMITS (SET
Page 137 and 138:
9.6 SAVE AND RECALL MACHINE CONFIGU
Page 139 and 140:
9.7 68705 Devices The 68705s are se
Page 141:
SECTION 10
Page 144 and 145:
10.1-02
Page 146 and 147:
10.2-02
Page 148 and 149:
A GRAPHIC EXAMPLE OF HOW THE INSERT
Page 150 and 151:
A GRAPHIC EXAMPLE OF HOW THE DELETE
Page 152 and 153:
LOWER LIMIT OF RE-LOCATED DATA By p
Page 154 and 155:
10.5-04
Page 156 and 157:
The new lower address limit can be
Page 158 and 159:
To increment or decrement the ASCII
Page 160 and 161:
10.7-04
Page 163 and 164:
INTERFACE 11.1 SETTING THE I/O INTE
Page 165 and 166:
(Revision 2) 11.1-03
Page 167 and 168:
Page 169 and 170:
Page 171 and 172:
Page 173 and 174:
Page 175 and 176:
Page 177 and 178:
Page 179:
SECTION 12
Page 182 and 183:
STRUCTURE AND CONVERSION OF DATA BE
Page 184 and 185:
CALCULATION OF THE INTELLEC* CHECKS
Page 186 and 187:
SBA REPETITION In some operations w
Page 188 and 189:
12.1.3-02
Page 190 and 191:
CALCULATION OF THE EXORCISOR* CHECK
Page 192 and 193:
1 - Data Record (Four Character Add
Page 194 and 195:
3 - Data Record (Eight Character Ad
Page 196 and 197:
CALCULATION OF TEK HEX CHECKSUMS Un
Page 198 and 199:
* Sections (e) and (f) are integrat
Page 200 and 201:
12.1.7-04
Page 202 and 203:
AND WITH AN OFFSET OF 8000 START CO
Page 204 and 205:
DEC BINARY DEC Binary is an improve
Page 207 and 208:
Page 209 and 210:
Page 211 and 212:
Page 213:
SECTION 14
Page 217 and 218:
14.2 REMOTE CONTROL COMMANDS h = on
Page 219 and 220:
SET UP FOR INPUT AND OUTPUT Selecti
Page 221 and 222:
14.3 REMOTE ERROR WORD -F- BIT NUMB
Page 223:
SECTION 15
Page 226 and 227:
15.1-02
Page 228:
I/O Interface: I/O Formats: Audible
show all

Stag PP39 Users Manual - Matthieu Benoit

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?