Stag PP39 Users Manual - Matthieu Benoit

INTRODUCTION OF A 39-MODULE TO THE MAIN FRAME
Having completed the setting up procedure the PP39 is ready to receive
its 39-Module. Controlling software for the machine resides in the
selected module, therefore the operation of the Programmer is dependent
upon the type of 39-Module plugged into the main frame.
On power-up the programmer will be configured automatically to what it
was before the machine was last powered down.
This ensures that once any machine parameter has been set-up, it needn’t
be reset every time the machine is switched on.
For instance, if the machine was previously used in the ‘LOCAL’ mode
with the 39M100 Eprom Module inserted, the initial configuration of the
machine will be set on power-up and the display will show the last
entered manufacturer, device type and selected mode, such as:
AMD 2764
GANG
To determine the software revision of the Module press ‘SET 6’ and the
display will show:
MODULE M100 07
To remove, press ‘EXIT’.
1.4-02