SECTION-E: TENDER AND CONTRACT FOR WORKS

38 of 77
stated :
(i) Dimension shall be measured to the nearest 0.01 metre.
(ii)Area shall be worked out to the nearest 0.01 sq.metre.
3.4. All measurement of cutting shall unless otherwise stated be held to include the consequent waste.
3.5. In case of fitting of unequal bore, the largest bore shall be measured for the test.
3.6. Testing of pipe lines fittings and joints include for providing all plant and appliances necessary for
obtaining access to the work to be tested and carrying out the tests.
3.7. The rate includes galvanized steel tubing with screwed socket joints, together with all fittings (such
as bends, sockets, springs, elbows, tees, crosses short pieces, clamps and plugs unions etc.) and fixing
complete with clamping wall-hooks, wooden plugs etc. and also cutting, screwing and waste and for
making forged (or hand made) bends on piping as required. Connector shall be inserted, where required
or directed. The rate also includes cutting through walls, floors etc. and their making good and painting
exposed threads with anti-corrosive paint as above and testing. Where tubes are to be fixed to wall,
ceiling and flooring, the rate shall not include painting of pipes, providing sleeves and sand filling under
floor for which separate payment shall be made.
3.8. The rate shall be for a unit of one running metre.
Item No.26
Providing & fixing galvanized mild steel tubes (medium grade) of 15 mm the following
nominal bore tube fitting and clamps including making good the wall, ceiling and floor.
Refer above item N0: 40 for detail specification.
Item No.27
Providing and fixing gun metal check or non return fullway 25 mm dia wheel valve
Please refer Item description.
Item No.28
Providing and fixing screw down bib taps of following size brass screw down bib tap
polished bright 15 mm
Please refer Item description.
Item No.29
Providing and fixing pillar tap, capstan head, screw down high pressure with screws shanks
and back nuts 15 mm dia
Please refer Item description.
Item No.30
Providing & Fixing readymade P.V.C. water tight storage tank made from linear
low density polythylene & low density polythylene LDPF product comfirming to I.S: 10146-
1982 with cover including providing & fixing one 20mm.dia. float valve ball-cock ,one
20mm.dia. G.I. Waste pipe with plug one 25mm.dia.G.I.Over flow pipe of length upto 0.03Mt.
including making all connection for inlet/outlet supply with necessary fittings for outlet/ inlet
etc., complete. (THIS ITEM SHALL BE OPERATIVE ONLY WHEN R.C.C. TANK IS NOT
POSSIBLE. FOR NEW CONSTRUCTION WORK THIS ITEM SHOULD NOT BE USED.)
500 liters capacity.
Please refer Item description.
Item No.31
Providing and fixing S.W. Gully trap with C.I. Grating (square mouth trap)
brick masonry chamber and water tight C.I. Cover with frame of 300 mm. X 300 size
(inside) with standard weight of 150mm X 100mm size - P or R type.
Please refer Item description.
Item No.32
Providing and Laying1200X2500mm. long readymade septic tank of approved
Signature of Contractor