Operating Instructions No. 705-2 USA
Operating Instructions No. 705-2 USA
Operating Instructions No. 705-2 USA
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
2. Preparing for use<br />
2.1. Special safety notes<br />
• Always turn off the power take off before carrying out servicing, maintenance, repair or<br />
assembly work on the rotary swather. Switch off the engine and remove the ignition key.<br />
Secure the tractor and rotary swather from rolling away.<br />
• Maximum drive speed is 540 r.p.m.<br />
• Actuating components such as ropes, pulling ropes, hydraulic hoses and cables should<br />
be laid in such a way that they cannot be activated unintentionally or come into contact<br />
with the tractor wheels. Accident risk!<br />
• <strong>No</strong>body should be between the tractor and rotary swather during raising or lowering<br />
operations. Extreme risk of injury!<br />
• Before switching on the PTO shaft, ensure that nobody is in the rotary swather danger area.<br />
Accident risk!<br />
• Check that the protective devices are correctly fitted in accordance with guidelines during<br />
operation and when using public highways. Attach the lights and check that they function<br />
properly.<br />
• <strong>Operating</strong> personnel must not leave the tractor when operation is in progress.<br />
Put the operation device into position before attaching/<br />
detaching units to/from the three point linkage in order to<br />
stop unintentional raising or lowering.<br />
Special care should be taken when coupling/uncoupling<br />
implements to/from the tractor.<br />
Risk of injury in the three point linkage zone by crushing<br />
or shearing.<br />
The swather is equipped with category I and II coupling<br />
lugs for the three point hydraulics.<br />
2.2 Connection to the tractor<br />
The swather is equipped with category I and II coupling<br />
lugs for the three point hydraulics.<br />
• Ensure that nobody is between the<br />
machinery and the tractor when<br />
connecting the rotary swather.<br />
• Ensure that the tractor has sufficient<br />
steering capability when the rotary<br />
swather is in the raised position.<br />
Increase the front axle load if<br />
necessary.<br />
– Install and secure the lower link arm.<br />
– Attach the top link arm and secure with bolts.<br />
– Raise the parking leg and secure it in the uppermost<br />
position with a pin. Do not remove the parking leg.<br />
The rear hydraulic lowering speed must<br />
be set (by adjusting the lowering throttle)<br />
so that the rotary swather chassis is<br />
slowly placed on the ground.<br />
KS200047<br />
12